Electronics Forum | Mon Jan 08 10:29:15 EST 2007 | jaime39
The water soluble flux residue is staying there because the rinsing temperature it may be too low. The flux needs about 130-140 degrees celcius to become soft. If you are using water soluble flux, as per IPC A 610 standards it needs to be remove comp
Electronics Forum | Tue May 23 12:18:25 EDT 2000 | mike weekes
Which companies would you consider for protective coatings, (conformal coating) and other levels of protection? I am taking a fresh look at alternatives. Know any good tests for testing compatability of coating with flux - aqueous or no clean? SMT
Electronics Forum | Mon Nov 01 21:50:32 EST 1999 | chartrain
No clean flux is really a misnomer. What is often taken to mean no residue in effect means no visible residue. Because you can't see it doesn't mean it isn't here. Many manufacturers have been through this same learning curve. The goal with a no clea
Electronics Forum | Sat Aug 28 09:23:36 EDT 1999 | Mike McMonagle
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Check out the EasyBraid website below, they carry IPC standard coupons, flux test kits and SIR meters at reasonable prices.
Electronics Forum | Fri Aug 27 11:27:55 EDT 1999 | Brian
I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead?
Electronics Forum | Wed Nov 17 11:20:23 EST 1999 | Dave F
Hey Gyver: If you don�t mind (which you don�t have any choice about, because I�m going to do it anyhow, cause it�s MY word processor), I�m going to respond genericly, but still be directed to your question. Much of the following is paraphrased from
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Wed Feb 22 20:33:25 EST 2006 | davef
Here's your design rules: * IPC-2221 * IPC-2222 Bonus is that they include the works, not just break-away tabs
Electronics Forum | Wed Mar 03 09:05:28 EST 2004 | davef
Look to IPC-2221, 9.1.3 Thermal Relief In Conductor Planes
Electronics Forum | Wed Oct 29 20:28:59 EST 2003 | davef
The possibilities are dizzying, aren't they? In our dingy fog, if we don't understand your requirement, say so. 3 Spec Fir Tree General Technical Specification 3a Design/Layout: IPC-2221 IPC-2222 3b PCB Fab: IPC-6011 IPC-6012 IP
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100