Electronics Forum | Wed Dec 11 07:05:28 EST 2019 | ameenullakhan
Hi, Below may help you out. per IPC 7093 ( Design and assembly Process Implementation for Bottom Termination Components ),Clause 6.1.5.3 voids on thermal pad up to 50% does not result in loss of thermal performance. Since the void criteria is
Electronics Forum | Sat Dec 02 10:23:47 EST 2017 | tomh
Have you ever heard of "Solder Mask Defined Thermal Pads"? I wrote a short blurb on this here - https://www.pcblibraries.com/forum/ipc7093a-btc-qfn-solder-mask-defined-thermal-pad_topic2154.html This technology saves fabrication costs by not havi
Electronics Forum | Tue Jul 04 20:31:21 EDT 2017 | davef
If you want in, 5-21h Bottom Termination Components (BTC) Task Group is in "Working Draft" revision from "A" to "B" of IPC-7093 - Design and Assembly Process Implementation for Bottom Termination SMT Components
Electronics Forum | Sat Apr 28 08:04:29 EDT 2018 | shuhaib
Hi, please go through IPC 7093, its only for design and assembly process implementation for bottom termination components. its says up to 50% voids will not reduce ant electrical and thermal performance.
Electronics Forum | Thu Sep 09 05:23:10 EDT 2010 | 15009
You can reduce and almost eliminate voids and other paste related defects in LGA's BGA's, QFN's etc, by using solid solder deposit. Its been around for 24 years, 13 in the US. It is now included in the new IPC 7093 specification for bottom terminat
Electronics Forum | Thu Aug 01 05:25:26 EDT 2019 | ameenullakhan
Hi , hope below information may help you. The presence of small voids in thermal pad region is not likely to result in degradation of thermal and electrical performance The combing of smaller multiple voids up to 50% of the thermal pad area, does
Electronics Forum | Fri Jul 27 09:47:20 EDT 2018 | davef
Adding to Rob's suggestions ... One of the theories about voiding in thermal / ground pads of BTC is: Solder starts melting at the edge of the pad and moves inward towards the center of the solder mass. This traps flux volatilizes. So, there needs t
Electronics Forum | Thu Mar 28 13:19:14 EDT 2019 | davef
There is no industry standard for BTC stand-off height. "IPC-7093A Design and Assembly Process Implementation for Bottom Termination SMT (BTC) Components" just finished "Final Draft for Industry Review" in December 2018. It mentions stand-off height
1 |
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100