303 ipc class results

Electronics Forum: ipc class (Page 1 of 31)

class 3 labor rate

Electronics Forum | Wed Aug 20 10:31:41 EDT 2003 | billdampier

We have some new customers that are requiring class 3 IPC standards, and my question is, how would that translate into a labor rate increase as compared to class 2 rates? I'm assuming the labor quote would increase by at least 15-20%, if not more. An

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

Electronics Forum | Thu Feb 05 14:30:29 EST 2015 | chsravan

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

Electronics Forum | Fri Feb 06 18:32:59 EST 2015 | chsravan

Hi Scott,Thank you for the response. I was also thinking the same that the assembly will no longer be Class III. Thanks again.

Can I apply IPC-610 class 3 workmanship standards to an assembly made with a IPC-600 class 2 PCB?

Electronics Forum | Fri Feb 06 11:11:04 EST 2015 | mascott123

I have asked that same question to a co-chair of the J-STD-001 committee who in turn checked with personnel at IPC. The answer I received is that yes you can apply the Class 3 assembly requirements using a class 2 PWB but the resultant assembly will

IPC Class II and Class III reliability

Electronics Forum | Tue Apr 08 12:38:12 EDT 2003 | Denise

I'm looking for comparison data on MTBF for solder joints meeting IPC Class II vs Class III.

Soldering Specification Needed

Electronics Forum | Mon Sep 26 10:58:37 EDT 2011 | dyoungquist

Basically in loose general terms: IPC class 1 is for consumer products that you discard when they break. IPC class 2 is for industrial products that last longer than class 1 products and you can repair when they break. IPC class 3 is for military

IPC Class II and Class III reliability

Electronics Forum | Wed Apr 09 09:36:18 EDT 2003 | iman

what r your test running parameters? what end-application?

BGA Specifications for IPC Class

Electronics Forum | Wed Feb 02 19:45:09 EST 2005 | ybt

try refering IPC-7095 Design and Assembly Process Implementatin for BGAs. I hope it helps.

IPC Class II and Class III reliability

Electronics Forum | Thu Apr 10 15:20:35 EDT 2003 | MA/NY DDave

Hi DaveyF, Thanks You see, you proved my point, with piles of more information than I gave. Based on Application rather than design and manufacturing specifications, a lower IPC class can out perform another. So our starting Poster must look at t