428 ipc j std 001 results

Electronics Forum: ipc j std 001 (Page 1 of 43)

IPC-A-610 and IPC J-STD-001 Updations

Electronics Forum | Mon Jul 24 07:18:51 EDT 2017 | jamesbarnhart

IPC has updated assembly standards for IPC A-610 and IPC JSTD-001 making them easier to use and adding information in areas that have evolved. Both IPC J-STD-001E and IPC-A-610E have also been more closely linked to eliminating the differences that c

Re: Assembly Types

Electronics Forum | Fri Dec 12 13:49:38 EST 1997 | Richard

Check out the IPC J-Std 001B

Solder Joint

Electronics Forum | Tue Jan 30 18:29:41 EST 2007 | realchunks

Sad part is THEY specified IPC J-STD-001C!!!

IPC J-STD-001E Ionic Cleanliness Standard

Electronics Forum | Fri Aug 30 22:51:14 EDT 2013 | cvogel

IPC-J-STD-001E in regards to Ionic Cleanliness standards states less than 1.56 µg/cm² of total NaCL. Assuming a typical electronic process which involves smt, wave, and post-hand soldering and uses NO-Clean flux throughout all process, is it typi

IPC-A-610 and IPC J-STD-001 Updations

Electronics Forum | Mon Jul 24 09:15:32 EDT 2017 | davef

James: This is not "breaking news." IPC-A-610F, Acceptability of Electronic Assemblies was released in July 2014. Both, ... * IPC-A-610G, Acceptability of Electronic Assemblies * J-STD-001G, Requirements for Soldered Electrical and Electronic Assem

Inspect workmanship through conformal coating

Electronics Forum | Tue Sep 06 12:41:52 EDT 2016 | kmclain

IPC J-STD-001 does not allow solder inspection to be combined with coating inspection for classes 2 and 3.

ROSE testing pass / fail

Electronics Forum | Mon Feb 21 20:15:49 EST 2022 | arminski

since IPC-J-STD-001 RevH obsoleted the 1.56ug/cm2 UCL of ionic contamination tester in testing using ROSE test, how do you define the acceptable limit per PCB assembly? thanks

How to qualify move from water wash SMT process to No clean?

Electronics Forum | Thu Jun 24 21:37:13 EDT 2004 | davef

IPC / EIA J-STD-001-C, Appendix B

Re: environmental testing

Electronics Forum | Tue Feb 24 18:21:52 EST 1998 | Graham Naisbitt

You should refer to the IPC-J-STD001B and IPC-TM-650, they will give you good recommendations. Also, we do new reliability test systems and if you can give me your address and e-mail, I will send you some more info. Regards, Graham Naisbitt | looking

IPC J-STD-001E Ionic Cleanliness Standard

Electronics Forum | Thu Sep 05 22:36:38 EDT 2013 | davef

Yes, providing your: * Inbound material does not compromise your process. * Soldering processes apply the proper amount of flux and activate it properly * Material handling does not contaminate your boards Recognize that the IPC requirements of less