Electronics Forum | Tue Feb 08 04:27:55 EST 2011 | thomas111
hi, I am a Hardware designer . One of my products is undergoing a Reliability test in which a resistor shows a high value on board from its specified value .However it retains the original value when its cooled under room temperature. The resistor
Electronics Forum | Wed Nov 28 22:33:24 EST 2007 | davef
There is no specification for lead-free HASL. You can use any lead-free solderability protection that meets your customer requirements. Use IPC-9701 �Performance Test Methods and Qualification Requirements for Surface Mount Solder Attachments� to ass
Electronics Forum | Fri Sep 29 13:51:46 EDT 2000 | C. Ortner
We work in a "low" volume high reliability house building mixed tech double sided multi layer CCA's for long lived space applications. Our present problem is inspection questioning every dimple/anomaly on every leadless part(we put passives only thr
Electronics Forum | Thu Dec 09 15:19:21 EST 2004 | nrocco
Can anyone point me in the direction to find some IPC standards for lead free solder joint reliablity tests, such as shear tests, pull tests, vibe tests, enviroment tests, etc. I need to know what the specs. are on all aspects of reliability and how
Electronics Forum | Thu Dec 09 17:45:27 EST 2004 | davef
You're correct. There is no criteria for no-lead, but there none for SnPb, either. Solder joint strength in pull/shear will vary with lead geometry, solder volume, lead metal/metallization, the way the test is done.
Electronics Forum | Wed Mar 30 16:46:03 EST 2005 | chunks
There is no spec because solder is designed to provide an electrical connection not a mechanical connection to hold the part on. If it where mechanical we�d be welding our parts on. Your pad width and length are derived from your component manufact
Electronics Forum | Tue Aug 02 22:49:55 EDT 2005 | davef
IPC-A-610D Section 5, shows a variety of photographs of: * Good lead-free solder connections * Lead-free soldering anomalies Hot Tear / Shrink Hole is one such anomaly. This shrinkage effect appears primarily on wave-soldered joints, but can also
Electronics Forum | Tue Jan 21 13:51:19 EST 2014 | rgduval
Armando, Is the problem in the same spot on the board with every run? If so, there might be something about that particular location that is part of the cause (ie. ground or power plane connection). It sounds like you're seeing blow holes, or insu
Electronics Forum | Tue Apr 16 05:05:32 EDT 2013 | stivais
We recently had a discussion with customer's QM - he claims that calculations for a proper solder wire diameter and soldering iron tip size (and temperature) have to be performed and documented for all manual (T/H) solderings (based on component size
Electronics Forum | Tue Jul 02 02:50:55 EDT 2002 | ianchan
Hi mates, was going thru the IPC-A-610C Standards, and noted BGA voids stands somewhere between 10%-25% voids permissible in the solder "ball" bump, after reflow process. Was wondering, hypothetical case study, is there any specification for voids
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100
