Electronics Forum | Sun Jul 29 21:33:30 EDT 2001 | CAL
Your Ionograph and Zero-ion Values are set by you. There is no raw pass of fail criteria only the limits you set up. Ionograph is great for bare board resistivity (salt) test just as a pass fail for incoming inspection but this is all per your facto
Electronics Forum | Mon Apr 29 12:32:18 EDT 2013 | stephendo
Do you watch when it is doing the wave height test? Watch it and see if it goes up to the same spot on the test probe each time. If the test probe is dirty sometimes the solder has to go up higher on it before it gets detected. You might actually be
Electronics Forum | Thu Jan 02 11:35:30 EST 2003 | Richard
Cleanliness test � �Area Grid Arrays�. Evaluation of residues� resistivity in a specific location on the board. (As compared to �Solvent Extract� evaluation.) We are: SMT assembly, using standard �water soluble� process with micro BGAs (example: C
Electronics Forum | Thu Sep 01 18:53:08 EDT 2005 | Board House
Pr. I agree with some of the above responses. if you are seeing Delam issues with incoming PCB's the following should be check. 1) Check the OEM Print to what Material they are calling out to be manufactured with. 2) If they are calling out for S
Electronics Forum | Wed Aug 28 06:12:53 EDT 2013 | hervé
i've a competitor selective soldering and i would like test the adique acide to clean the nozzle. How much do you use approximativemely to clean a 8/4 mm nozzle?
Electronics Forum | Thu Sep 17 12:00:19 EDT 1998 | Mike C
| | I need an evaluation process to prove to a customer that our no-clean process does not leave excessive residue? Any ideas? | Wayne: More of the same as Chry and Justin. | KEY ISSUE | The first thing that you need to know is: What does your cus
Electronics Forum | Mon Apr 29 13:56:19 EDT 2013 | williamaxler
We have a Versaflow 40/50 and ours is setup like this. We have out nozzle test position set so that in the Z axis you are 3.8mm away from the pin. Used feeler gauge Then you can set your gradient per nozzle. Start with a number then do a wave offs
Electronics Forum | Thu Apr 25 09:57:31 EDT 2013 | jaimebc
We aquired an ERSA ECOSELECT 2 selective soldering machine. So we are going through a learning curve and I would like to hear from ERSA users on this subject. The main concern is to keep the miniwave steady, it seems that it " bounces" a lot and is
Electronics Forum | Thu May 02 14:58:20 EDT 2013 | stephendo
Kurtz had a guy that was great with the machine. I strongly suggest that you watch the wave height test a few times in the morning then at lunch and at the end of the day. Look where the solder goes up to on the probe. If it doesn't work consistent
Electronics Forum | Mon Jun 12 18:44:30 EDT 2006 | muse95
OK, Pete, I just looked all through IPC-A-600G. Saw no mention of scoring anywhere. Please provide specific section number info. Thanks By the way, Chris, thank you for the information - that is really interesting stuff. Would you be willing to a
