Electronics Forum | Wed Feb 09 10:40:56 EST 2005 | primus
Another question about Set Command Variables. We use fixed dimension, multiple window PCBs in all of our UIC machines. It is often required that we use the rotary table to populate the entire panel, but this means that for each rotation, either the w
Electronics Forum | Mon Jun 19 20:55:18 EDT 2006 | Thanagon
Try to dip that wire with flux before insert to PCB. IT's will come better .
Electronics Forum | Thu Oct 23 10:28:00 EDT 2003 | lawrence
I owns a 1992 Dynapert VCD-G axial inserter, have face difficulty in locating Board level spare parts. Would appreciate help from your recommendation.
Electronics Forum | Thu Jul 09 05:52:49 EDT 2015 | kfquan
Have you tried the so called push-back or re-insertion type panel? 5mm*12mm*0.3mm thick FR-4, 120-up panel is doable.
Electronics Forum | Thu Apr 30 09:27:58 EDT 2020 | clockwatcher
I currently have a board that has several wires that need to be soldered into it. Many years ago I remember wave soldering power supply boards that also had many wires. In order to keep the wire insulation out of the solder fillet and keep the wires
Electronics Forum | Thu Apr 18 16:52:15 EDT 2002 | davef
General comments are: * First place I would look is the supplier of the pins that you are trying to install. Most suppliers that sell press fit components have done a good deal of work to qualify the component and will have all the specifications yo
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Thu Feb 15 02:19:50 EST 2018 | Robl
Hi Leadthree, We have a combination of methods depending on volume, value, size, level of build, and what the customer does with them. So on high volume low value we have rigid plastic ESD boxes with lids, foam lined, that layers of custom vac form
Electronics Forum | Mon May 14 18:31:20 EDT 2001 | genny
The experiment was to determine insertions from a > gold plated board into a connector. Same > thickness boards (0.062"), with 100 m base > nickel. � 100m gold =_ 500 insertions � 50 m > gold =_ 300 insertions � 30 m gold =_ 50 to 75 > insertio
Electronics Forum | Tue Aug 28 23:53:31 EDT 2007 | crashoveride
dedicated fixture works best if the board is very much populated. But if the parts to be inserted are less than 300components, adjustable fixtures may be used. But the secret of good insertion is a precisely measured tooling pin to prevent the boards
.gif)
winsouce.jpg)
