Electronics Forum | Thu Oct 22 14:37:27 EDT 2020 | kumarb
Hi. Did a similar update to our Emerald-X (YV88X) and the USB Floppy Drive emulator works like a champ! Installed within a few minutes with 100% success. Way more elegant than 1.44M floppies. Can you share more details on the FD Emulator you have so
Electronics Forum | Thu Jan 03 10:32:38 EST 2013 | beej
I was wondering if any of you fine folks had a trick to changing out nozzles for a Pillerhouse Jade Handex. The tool they gave us when we purchased the machine is inadequate at best. I have tried heating the nozzle up, to no avail. Just wondering if
Electronics Forum | Fri Aug 19 08:32:54 EDT 2022 | angela t
The GKG G5 press has occasional drive alarms, sometimes it turns off and restarts, sometimes it needs to be unplugged from the board cable at the back and the alarm returns after a period of production. What is the problem? Could any of you give me a
Electronics Forum | Mon Nov 21 15:53:38 EST 2016 | teslalab2
Ok thanks for you help. I am up and running again. I had thought about the upgrade, but it would never pay off in my little garage operation.
Electronics Forum | Fri Jan 14 16:55:31 EST 2011 | tombstonesmt
On our Pilarhouse Jade we use nitrogen to cool the belt that drives our solder pump as well as keep the amount of oxygen to a minimum in our solder pot to reduce dross.
Electronics Forum | Fri Dec 30 20:12:47 EST 2022 | ttheis
I found a broken COM3 connector on the fluxer interface board where the PC comms go through and replaced the connector. Now when trying to establish communications the exhaust fan turns off briefly a few times then it times out and reports a failure
Electronics Forum | Thu Dec 06 12:37:14 EST 2012 | deanm
We are having difficulty with bridging on a 2x50 pin 0.050" fine pitch connector using our selective soldering machine. It usually bridges at the end of the row, but sometimes it bridges all the pins together as it drags across (solid bridging). I
Electronics Forum | Mon Aug 30 17:21:46 EDT 2021 | jamesatqkits
So it was the drive, I was able to swap the conveyor drive for the mirror drive, these 2 drives are the same luckily. Just tapping lightly on the head would cause a 22 error to appear on the drive, at first I thought the motor must be bad. After talk
Electronics Forum | Wed Dec 12 16:12:58 EST 2012 | tombstonesmt
Glad to hear we have more Jade users on the forum! What kind of flux footprint is your fluxer leaving on the board? You called it a "spray" fluxer.. We use the MIC fluxer that functions like a jet fluxer. Do you flux each individual lead or do a
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
