Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Thu Jun 30 18:31:28 EDT 2005 | KEN
Make sure your RS232 is screwed in and not loose. Verify your PC is not hanging up and locking up the com port (windows can really suck some times). I would scan-disk and defrag. I bet its not a furnace problem, but a PC problem.
Electronics Forum | Wed Jan 24 16:40:07 EST 2007 | chrisgriffin
Not as wack as Nancy Pelosi being Speaker of House. But back to the topic, Grid Lock kicks ass. You can even adjust the amount of force of the pushers that come up to the board. Your pads must be right on the edge. Might want to look into break-a
Electronics Forum | Tue Jun 05 16:12:51 EDT 2012 | kahrpr
We use both The pin placement works fine for the mpm. If its a dense board you have to to some double checking on the initial set up. On the dek we use Grid lock. For us its toss up which is better they both work.
Electronics Forum | Fri Oct 18 07:10:40 EDT 2019 | bk
The lock is manually being able to twist into the lock position and unlock by twisting in the opposite direction. I highly doubt that this is the real problem. First check the rings on the tool to see if they are too worn to hold in the mount head. S
Electronics Forum | Wed Sep 25 13:12:25 EDT 2002 | dragonslayr
Dave (and Brian) - OK, following the logic of your post above sounds good. I now have questions. How would a user know to follow your suggestion? Especially a newbie? How would a new posting be titled so that it has relevance to a "locked" thread?
Electronics Forum | Mon Jun 23 13:01:54 EDT 2008 | wschulz
Hey guys, My company is currently looking into developing a SMT line. I have an interesting perspective on this due to the fact that I worked a SMT line for quite a few years as an equipment operator. Now I am an engineer and at a different company
Electronics Forum | Fri Oct 16 09:48:24 EDT 1998 | Jim Lewis
Help required on vision verify on Quad 4C/Mk2. In component editor, vision verify is OK. When linked into program, the following message occurs: "Bad or missing component description" Machine locks up. Can we get around this? If so how?
Electronics Forum | Wed Oct 24 12:18:03 EDT 2001 | Hussman
It's usually up to the board house. They use their lines to make a variety of other customers boards and never want to be locked into using a special mask. I'd task your QC department to catch and return these boards. That usually straightens out
Electronics Forum | Tue Apr 05 12:45:01 EDT 2005 | cyber_wolf
Make sure your matrix tray is up high enough. The components in the matrix tray should be at least at board level. Also check your component height in the package list. If all that is OK then, check those Z locks I spoke of earlier.