Electronics Forum | Thu Feb 24 16:35:02 EST 2000 | D Scott
Larry, I have seen this problem on our IP-3 also. You can recover from this without powering down by going into the I/O page and turning off that particular function. The machine should be fine once you exit out of the I/O page. It almost acts like
Electronics Forum | Fri Nov 16 10:58:31 EST 2001 | slthomas
Short of locking them up and checking them in and out (and writing up your operators for not checking them back in at the end of a shift), I dunno. In short, I think ya gotta be a tool Nazi. We only use hand tools (assigned to the operator's pers
Electronics Forum | Wed Aug 09 12:22:11 EDT 2006 | Rob
You are going to struggle with that sort of connector - the only pin headers that seem to have widespread sucess are the dual inline ones with bent over j leads that sit on the board. They come with a plastic hat that allows vacuum pick up. However
Electronics Forum | Fri Aug 11 13:40:13 EDT 2006 | chrisgriffin
MPM fan, thanks for the suggestions. I like the way you think. But I forgot to mention the most important thing. It only does this a few times per shift. The rest of the time it works fine. But we must re-boot every time due to the computer lock
Electronics Forum | Fri Oct 31 14:09:07 EDT 2014 | wbrenner
Having a problem with a DEK printer. In the back to front motion, getting poor ramdom paste volume on micro BGA pads. Other BGA 1 mm pads are fine. The front to back motion is fine. Any throufghts on this directional issue. Ran ~200 panels no pr
Electronics Forum | Wed Dec 02 14:33:12 EST 1998 | fuji god
| Our CP feeder take up reels often break,The glue in tabs | are a pain and replacement is expensive.Any solution? | Be sure that you are using the correct take up wheel with the correct feeder. There are two distinct types of take up wheels, one
Electronics Forum | Thu Mar 04 15:01:32 EST 2021 | proceng1
We used to have 5 of these in service and they worked great. Only 1 had the stencil wiper, and we did not utilize it. We've since installed all inline printers, but we do keep 1 MV100 on the floor as a back up. The firmware can get squirrely and the
Electronics Forum | Tue Mar 16 17:06:28 EST 1999 | GSM GURU!
We are dealing with down time accredited to the Pumps getting clogged with dried glue. We have decided to purge all spindles at 6 hour intervals. We are looking at making this process automated. Has anybody tried this and if so, is there a way to set
Electronics Forum | Mon Aug 06 09:42:52 EDT 2001 | edmentzer
We have the machine you are talking about, and yes Linux is a great OS much better than anything MS has ever put out. The machine is easy to use and program, the OS is rock stable unlike Windows. Our last machine ran Windows and our oven runs Windo
Electronics Forum | Fri Oct 01 13:14:10 EDT 2004 | dorklover664
The MPM's are the Yugo's. You can fix anything on it with duck tape and a rubber band. I would go with the DEK. They are user friendly and reliable. Just make sure that if you are running double-sided boards to look into good push-up pins. They have
