Electronics Forum | Tue Jan 03 12:33:23 EST 2023 | stephendo
Is there any RS232 to USB involved with the machine? I'm guessing that it is a new to you machine that had been running before you bought it. We had an oven like that that would not find the machine. I noticed that a setting had been 2 then later w
Electronics Forum | Thu Aug 04 14:01:56 EDT 2022 | ttheis
We are having an issue with a Jade S200 we recently purchased. When opening the pillarcom software it is unable to establish communication with the machine. The power supplies and fuses all seem to be ok and at proper voltages. Checked as many connec
Electronics Forum | Thu Aug 04 21:51:45 EDT 2022 | ttheis
When I press the green start-cycle button the 42V=E light illuminates but the 24V=E light does not. Could this be related?
Electronics Forum | Sat Dec 31 00:52:33 EST 2022 | sarason
Next step trace the RS232 cable. Check all output voltages on your power supplys, b oth loaded an d unloaded. Note any differences. Check he impedancesa of your loads ie is your 24 volt load only measuring a few ohms. You may have a short? sarason
Electronics Forum | Fri Dec 30 20:12:47 EST 2022 | ttheis
I found a broken COM3 connector on the fluxer interface board where the PC comms go through and replaced the connector. Now when trying to establish communications the exhaust fan turns off briefly a few times then it times out and reports a failure
Electronics Forum | Fri Jun 21 06:41:58 EDT 2019 | jackson_jade4
hello, nice to meet you my name is jackson jade, i'm also new in this forum,want to engage myslef in productive discussions.
Electronics Forum | Fri Jun 08 17:06:41 EDT 2012 | tombstonesmt
We have many Pillarhouse Jade Mark II's in our facility. Lately design engineers have taken a liking of huge ground planes in boards. Quite honestly with topside heaters some of these boards were impossible to solder. True you can preheat with the no
Electronics Forum | Fri Sep 30 07:15:17 EDT 2011 | deanm
We are using Kester 985M in our Pillarhouse Jade. We only run SnPb, but this is a newer formulation of flux that is suitable for both lead and lead free alloys. Call the manufacturer of your selective soldering machine and get their advice. They ty
Electronics Forum | Thu Dec 06 12:37:14 EST 2012 | deanm
We are having difficulty with bridging on a 2x50 pin 0.050" fine pitch connector using our selective soldering machine. It usually bridges at the end of the row, but sometimes it bridges all the pins together as it drags across (solid bridging). I
Electronics Forum | Tue Oct 16 10:06:46 EDT 2012 | jackofallmasterofnone
Hello all, First off let me start by introducing myself. My name is Dan and I work for a contract manufacturer. During a job search I had heard from a previous co-worker that there was a packing job available at the facility where he now worked. I
winsouce.jpg)
