Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef
I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and
Electronics Forum | Wed Aug 25 09:14:20 EDT 2010 | ozgurv
Dear all, Is there anybody who has got experience about the hollow jet wave soldering system? Is it usefull for SMD devices such as fine pitch components and Can it solder components which are on thick PCB's? Thanks.
Electronics Forum | Mon Feb 27 05:48:29 EST 2012 | sparrow
Hello, does anybody use a Kirsten jet wave soldering system? we think of implementation of wave soldering process at our facility and Kirsten jet wave systems with protecting liquid looks pretty attractive to us (N2 is no needed). Can anybody, w
Electronics Forum | Wed Mar 21 06:13:42 EDT 2012 | sparrow
Hello Hunzo, many thanks for your detailed reply! By the way, I am well familiar with the smell of Galden liquid that is used in vapour phase soldering ovens. Does ADL have the similar smell?
Electronics Forum | Wed Mar 07 02:29:22 EST 2001 | Cosine Theta
Barcode needs a light colour backgroup so that the scanner can read. No way you can mark on the solder mask and become readable. I found most of the time the investment cannot be paid back within 5 years. Most of the time it is product requirement th
Electronics Forum | Wed May 25 19:25:24 EDT 2022 | jojoled
Thanks "Spoiltforchoice" for Informations, I have found allready a Chinese company which has such machines, just wanted to check other options from other countries too. I know it is from other end of linear process, but from my point of view (plus wh
Electronics Forum | Thu May 26 07:53:42 EDT 2022 | jojoled
Hi.Thanks for reply. 1. - I guess after JETting the paste, the head will go aside, to allow head with HD camera(SPI) to do the job.....and thus if used for AOI , the same camera will be much higher above components, not damaging anything....this is
Electronics Forum | Wed May 25 23:45:04 EDT 2022 | SMTA-64387687
1. The jetting head flies very low to the level of the board. So, performing AOI function will crash the head. 2. AOI is performed close to the end of the line, after P&P or reflow. Are you planning to run the boards back-and-forth, on the line? 3. L
Electronics Forum | Tue Nov 08 16:21:37 EST 2011 | nevercry14
Cannot zero set machine actuator problem need help.
Electronics Forum | Wed Nov 09 08:29:51 EST 2011 | nevercry14
Found y sterper motor not working .nthanks for the info.
