Electronics Forum: jetting ink viscosity (Page 1 of 2)

laser or ink jet marking of pcb's

Electronics Forum | Tue Mar 06 18:57:48 EST 2001 | pzohbon

I am looking at putting a laser or ink jet marking system for barcoding of pcb's in our smt production area. As and inline system it will need the capability to handle different size boards. We use dark green pcb's except for couple red and blues m

laser or ink jet marking of pcb's

Electronics Forum | Wed Mar 07 02:29:22 EST 2001 | Cosine Theta

Barcode needs a light colour backgroup so that the scanner can read. No way you can mark on the solder mask and become readable. I found most of the time the investment cannot be paid back within 5 years. Most of the time it is product requirement th

laser or ink jet marking of pcb's

Electronics Forum | Wed Mar 07 20:37:38 EST 2001 | davef

I agree. The bar coded label you use should not be affected by the solder mask of the board. The label should have sharp contrast between the segments of the code to modulate the returned light and allow the reader to discriminate between light and

laser or ink jet marking of pcb's

Electronics Forum | Thu Mar 08 09:38:35 EST 2001 | blnorman

We've been using pre-printed labels on our PCB's for years, with 8 - 10 hours a week down time associated with them. Last October we put a CO2 laser marker on one of our lines. In 6 months we've had a total of 30 minutes down time. We use a 2D b

Other Jet Printer besides MYCRONIC?

Electronics Forum | Wed Jan 23 23:45:35 EST 2019 | kiransahu

Piezoelectric type (office/industrial) In this method, a piezoelectric (piezo) element, whose volume is deformed when voltage is applied, is used to discharge ink particles. This element is attached to the component that is filled with ink. Then, th

Inkjet marking system

Electronics Forum | Tue Aug 10 14:12:53 EDT 2004 | Fillmore

The alternatives are ink-jet and laser and you'll spend way over $20,000 for that solution! Screen printing is still the best at ROI when doing multiple panels and lot's of legends. We used a rubber stamp inked with Hysol for smaller quantities and o

Best Jet Printer? MY600?

Electronics Forum | Fri Feb 05 15:15:01 EST 2016 | jfbrandon

Why don't you look into a BotFactory Squink? It can deposit solder and pick-and-place. It prints conductive ink for the traces too. $3K is probably spot on for your budget. Check out http://www.botfactory.co

Conformal Coating Equipment - Where to Start?

Electronics Forum | Fri Jun 12 13:28:23 EDT 2009 | dontfeedphils

Asymtek in-line machine with the Jet head hands-down. And since you will be coating silicone you should virtually have no touch-up after it exits the machine because of the higher viscosity of this material.

Dover Coporation selling Vitronics Soltec

Electronics Forum | Fri Sep 01 15:33:29 EDT 2006 | Cmiller

Rick, I think Autosplice and Berg did that but of course, it was a little before my time. But the comparison is the same as what HP does with injet printers and the ink cartridges which for some reason made me think of a screen printer someone made t

Removing Markings from Devices

Electronics Forum | Tue Apr 29 11:18:16 EDT 2008 | bandjwet

All: I am interested in how process engineers are both removing and adding markings to active devices. We have a job where we have to both remove the markings of and the re-mark SOICs. The markings on the devices look like they are pad or ink jet p

  1 2 Next

jetting ink viscosity searches for Companies, Equipment, Machines, Suppliers & Information