Electronics Forum | Mon Sep 09 11:36:17 EDT 2013 | moussa
We have an unloader jot Automation : - NO:35036A-7.1 - code:J213-25.5/5 - SNO:10201646 0.4) The problem is that the PT control give an error message witch is : “No direct information is set! use the support tool to set the PT control area and PT
Electronics Forum | Sun Apr 17 09:35:33 EDT 2005 | ozgur.varol@basari.com.tr
I have one of these too and � have manuals about jot conveyour but my conveyour has a pot for adjust the speed � can send conveyour's electrical schmatic to you as a jpeg format
Electronics Forum | Tue Apr 19 11:52:29 EDT 2005 | Dan
Dpoormon@surmotech.com
Electronics Forum | Thu Apr 14 06:10:12 EDT 2005 | dj_jago
JOT were taken over by Elektrobit a couple of years ago. Try contacting them for the information. Do a web search for 'Elektrobit' for contact details.
Electronics Forum | Fri Apr 22 08:00:50 EDT 2005 | bobpan
we had schematics and a disk inside the rear cover assy in ours. You may want to check under that cover.
Electronics Forum | Tue Apr 12 10:18:31 EDT 2005 | Dan
I have one of these before our oven, and there is no way to control the speed of the belts. Checking their website produces nothing. We have the unit open, but nothing inside appears to be adjustable. Anyone know where I can find a manual for this? P
Electronics Forum | Thu Jul 11 14:10:55 EDT 2024 | jsmith01
Would anyone have a manual/schematics for a Jot J204-50.4/12 conveyor? Thank you
Electronics Forum | Sat Oct 21 20:53:15 EDT 2006 | Ola
Of course. It has a dynamically programmable PLC. This means that you can program it into virtually whatever you want it to do, as long as it is within that particular conveyour specification. JOT doesn't normally give this "s/w manual" and "the han
Electronics Forum | Fri Aug 17 09:42:18 EDT 2001 | Hussman
G'Day All, I have a couple of new Panasonic MSR's. Whenever I load a new program into the machine, I have to manually feed the first PCB onto the X/Y table to get it to run. After that, they run just fine. Panasonic is going to be in and they hav
Electronics Forum | Tue Aug 09 17:01:59 EDT 2005 | dougt
Is there a need for a professional conveyor swapper? Could I start my own business and make enough money doing something like this? I haven't worked on this conveyor but I'm sure I could figure it out. As it was said previous it's probably only a c
| 1 |
