Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Thu Apr 21 06:11:03 EDT 2011 | fadzril
Dear Lisa, as for current, we're using Sony SI-F130 & G200 machines. for my personal opinion comparing to Pana HT122 & JUKI KE2060, Sony machines are very delicate to handle. the precision is good, especially 0603 parts, but for maintenance-wise, it
Electronics Forum | Sat Jun 07 23:37:34 EDT 2014 | demzvill
Hello all Good morning. I just want to ask with you guys about the problem that we always experienced in our production. We could not get our target ppm due. to inverted placement of chip resistor. We are using 2000 series juki mounter and cf03hp j
Electronics Forum | Fri May 27 14:37:05 EDT 2005 | Frank
Look into the Juki KE-2060E machine. I have been extremely pleased with this machine. It will hold 80-8mm feeders, place 0201 (0603-metric) up to 74mm square ICs and BGA, 150mm long connectors. Up to 25mm tall components. It can handle up to 30 t
Electronics Forum | Wed Nov 16 06:02:23 EST 2005 | stefwitt
Are feeders included? Otherwise, the MS 102/132 sell even for lower prices here in US. Add shipping and training and you get to the same result. Juki, Contact and Quad may fall in the same price range, but spare parts and service tech availability wi
Electronics Forum | Thu Jun 02 18:16:26 EDT 2005 | URI
Look into the Juki KE-2060E machine. I have been > extremely pleased with this machine. It will > hold 80-8mm feeders, place 0201 (0603-metric) up > to 74mm square ICs and BGA, 150mm long > connectors. Up to 25mm tall components. It can > ha
Electronics Forum | Tue Jul 12 17:53:02 EDT 2016 | muzzy
Hi! If You have manuals in PDF form, I would be very grateful if You could send them at: muzzybox(at)o2(dot)pl. Thanks. Regarding Your problem with 0603 resistors - I'm not an expert when it comes to using this machine, but I think there could be a
.gif)
