Electronics Forum | Tue Jun 14 17:10:43 EDT 2005 | peter ng
Dear all, I need some information about the Juki 750,760,2010&2020 1)actual vaccum level (with&without nozzle)-after measure 2)blow level(without nozzle)-after measure 3)Is the unit for Juki blow & vaccum level in KPA or mmHg? Thanks!
Electronics Forum | Wed Jun 15 00:14:27 EDT 2005 | fdr4prez
Contact your local Juki Service Office, they should be able to supply these answers. Or post your data and other users can compare them with their equipment. The units of measure can be in either kPA or mmHg. This is dependent on the units of meas
Electronics Forum | Thu Aug 25 17:31:10 EDT 2011 | emeto
Hi, we have 740 and I would never assume that it can place 0201. The new Juki machines like 2060 1080...can do it for sure but older machines I doubt it.
Electronics Forum | Wed Aug 17 12:14:52 EDT 2011 | emeto
We hacve Juki and I have to admit that they are very good machines. These machines are not very fast(I don't know how different is 2080. 1080 aned 2060 are almost the same and their real speed is about 6000cpm/h. Besodes that fact the machines great
Electronics Forum | Fri Apr 21 07:18:40 EDT 2023 | spoiltforchoice
I had quotes for a MY100 -14 a Juki KE-1080 and an iPulse M6ez back in 2011 and at that point all those machines were about the same price with a light feeder package. The MyData however was the only one configured with smart feeders, a tray feeder a
Electronics Forum | Wed Jun 05 15:15:37 EDT 2019 | cristian_amlima
Hi Guys.. greetings! I hope someone could help me. Does anyone knows how to configure a gripper nozzle to juki 700 series? (more specifically FS730). With this nozzle the machine should blow to inflate the nozzle and I don't know how to change from
Electronics Forum | Tue Nov 08 01:46:43 EST 2016 | sarason
Some machines use air blowing to not only place the part but to also help guarantee that when the nozzle is sucking it doesn't end up with a net accumulation of solder paste inside the nozzle. Juki and Yamaha spring to mind. sarason
Electronics Forum | Wed Feb 13 07:00:59 EST 2013 | spoiltforchoice
Low-Medium volume and Low Budget are difficult for others to quantify. I'm not familiar with GEM's but if the AX-201 suggested above can use your existing feeders its obviously got a leg up on the competition. Otherwise, to some extent your choice mi
Electronics Forum | Thu Dec 08 11:50:40 EST 2005 | Stefan
If you mention mis-alignment and missing component in the same sentance, I suspect the component is not properly released after placement. Assuming the Juki machines use an air blow, after vacuum shut off, than I would look at a correct air flow firs
Electronics Forum | Mon Sep 24 06:01:38 EDT 2018 | lozie
hello, I suppose you didn't put any placement offset in the component placement settings. did you perform the general calibration of the lasers? with the supplied calibration tool that comes with the machine. check MSP parameters, as there might b
