Electronics Forum | Thu Jun 18 15:04:32 EDT 2015 | empac
We have Juki 2000 series feeder carts. Let us know if you have any interest. Thanks.
Electronics Forum | Tue Mar 04 10:36:10 EST 2014 | charliedci
We have a KE2060, 2080 and an older 750. All of these use same feeder trolleys. I presume the 2020 and 1070 also offer same trolley compatibility. If machines are not set up for trolleys, you will need conversion kits to utilize trolleys, which sho
Electronics Forum | Thu Feb 27 15:21:37 EST 2014 | idscraigsmith
My company uses a Juki KE-2020L and a Juki KE-1070L pick and place. I am trying to locate feeder trolley's with feeder banks that would be compatible with these machines but am having a hard time finding anything. Anyone have suggestions of where t
Electronics Forum | Fri Feb 28 03:13:16 EST 2014 | smtspareparts
Craig,we just make juki cf/af/ff feeders,but hasn't encountered such problems,perhaps I did not very understand the intention,normally install reels on proper feeders,and install feeders on proper position of feeder trolley,but you want realize more
Electronics Forum | Mon Mar 19 20:58:45 EDT 2007 | Steve
I have a project I would like to consider a Juki machine for. I am trying to find out if a Juki 2000 series machine can pick up parts from 12mm and 16mm simultaneously with all heads for good optimisation performance? IE are the heads spacing the sam
Electronics Forum | Sat Mar 25 16:27:51 EST 2006 | Frank
I would rather keep my Juki KE-2060. It runs faster, do larger boards, and can place a wider range of components when compared to the Opal. Also, I have trolleys on front and rear, without losing any feeder locations. Why can't you put trolleys on
Electronics Forum | Thu Sep 27 10:20:46 EDT 2001 | John S
The feeders on the Juki 750 machines have about 0.060" slop in the x-axis. Which allows the machine to try to pick up the part on the edge,inverting it. With the auto-correct feature enabled, the machine locates the feeder pocket based on its pick
Electronics Forum | Tue Jun 10 22:57:18 EDT 2014 | demzvill
Our observation also is that the tape size is too big for the chip which allows the tape to move around. With this i would like to know if there is is a setting in the machine that would slow the feeding rate. We are using juki mounter 2000 series. A
Electronics Forum | Sat Jun 07 23:37:34 EDT 2014 | demzvill
Hello all Good morning. I just want to ask with you guys about the problem that we always experienced in our production. We could not get our target ppm due. to inverted placement of chip resistor. We are using 2000 series juki mounter and cf03hp j
Electronics Forum | Fri Apr 06 02:17:15 EDT 2018 | rob
@ Sr.Tech, Most of our Chinese spares are Juki & Yamaha original & still bagged, just much cheaper. They wouldn't sell machines in China if all the spares and consumables were at European mark ups. Nozzle wise the Juki 750 & 760 copies are not 100%
.gif)
winsouce.jpg)