Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Tue Oct 20 23:14:01 EDT 2015 | kiwiguy12345
Hi, I have struck a problem with the X axis on my Juki 740. As soon as I "home" the machine the X driver displays the code "961" Does anyone have any ideas as to a solution for this problem? Thanks!
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Sat Oct 21 17:41:05 EDT 2023 | basil_rv
Hi all! While operating the JUKI JX-350LED, error E600016 (Since the Z-axis is descending, it cannot operate) appeared. During initialization, this error appears, although all heads are raised. Rebooting and turning off the heads did not help. Wha
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Thu Aug 20 19:30:45 EDT 2020 | aurash
Hi Guys, I 'm having trouble with a JUKI KE2060 - multiple errors on Z, X, Y axis (it seems that the problem moves around) - the error codes are E602137 E603112 any help or an electrical diagram of the machine are highly appreciated A
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
winsouce.jpg)
.gif)
