Electronics Forum | Wed Mar 23 13:19:40 EDT 2011 | bwjm
Charlie, thanks for the reply. But I am still unclear with the machine capabilities. Does the standard ke740 able to place 01005 components or is it the machine was upgraded to place 01005? This is my first time getting a placement machine, I am quit
Electronics Forum | Tue Jun 14 17:10:43 EDT 2005 | peter ng
Dear all, I need some information about the Juki 750,760,2010&2020 1)actual vaccum level (with&without nozzle)-after measure 2)blow level(without nozzle)-after measure 3)Is the unit for Juki blow & vaccum level in KPA or mmHg? Thanks!
Electronics Forum | Wed Jun 15 00:14:27 EDT 2005 | fdr4prez
Contact your local Juki Service Office, they should be able to supply these answers. Or post your data and other users can compare them with their equipment. The units of measure can be in either kPA or mmHg. This is dependent on the units of meas
Electronics Forum | Tue Apr 11 20:23:19 EDT 2000 | Dave F
Ashok: You're still goin' down that ol' ESD road aren't ya bud? Why do you need the boards to be dry? Conformal coating? Hey wait a minute, are you one of those no-clean people? Er zis related to the Kapton tape res fandango? Anywho, be careful
Electronics Forum | Tue Feb 22 12:02:11 EST 2005 | siverts
The first thing to do, as always with any trouble shooting, is to try to isolate your problem area, then it is much easier to pinpoint and find a solution for the problem. Some simple checks you can do, besides the good suggestions you got from some
Electronics Forum | Thu Aug 25 17:31:10 EDT 2011 | emeto
Hi, we have 740 and I would never assume that it can place 0201. The new Juki machines like 2060 1080...can do it for sure but older machines I doubt it.
Electronics Forum | Wed Aug 24 12:10:20 EDT 2011 | atgservice
Hi All I need some advice , hope you guys can help. Is Juki KE750 able to mount 0201 components? Well, according to the nozzle catalogue, there is a special nozzle ( No. 149 ) which is smaller in diameter than the Nozzle 101. It says that this noz
Electronics Forum | Fri Aug 26 16:28:27 EDT 2011 | fredc
I have a copy of the Juki catalog "e" and it shows the 750 capable of 0201s but not the 760. We have several customers that get 149s from us to place 0201s. We have also made a custom 101 with one small hole for several machines that would not re
Electronics Forum | Tue Jul 03 08:14:49 EDT 2001 | Stefan Witte
If you hold your board sideways in a 90 degree angle you apply a force of 1 g to your components. 1 g translates into 32 ft / sec. square. This is not too much acceleration for fearless roller coaster drivers but Melf�s and Tantalums can fall off at
Electronics Forum | Thu Dec 08 11:50:40 EST 2005 | Stefan
If you mention mis-alignment and missing component in the same sentance, I suspect the component is not properly released after placement. Assuming the Juki machines use an air blow, after vacuum shut off, than I would look at a correct air flow firs
