Electronics Forum | Wed Jul 21 01:27:17 EDT 2004 | simmcircuits
Hi, I need help in aligning the stencil and the board on an MPM AP25. I have no calib jig and stencil what I did was edit w/dos editor the file ap.cal. It seems to be working OK now just a little bit of offset but what I'm concerned is the software t
Electronics Forum | Mon Oct 22 10:35:54 EDT 2007 | mulder0990
We use Microsoft Access to track our feeders. I have made a system for the machine operators to tag the feeders when they run into problems. We seem to be having a lot of pitch issues. I am wokring on geting a calibration jig to solve that issue.
Electronics Forum | Tue Jul 27 19:02:46 EDT 2004 | pdeuel
Not an easy task and requires calibration jig. MPM support field service is your best bet. The adjustment screws for the prizm located on left side of camera will adjust the x direction. There is a set screw on the front that must be loosened first.
Electronics Forum | Fri Sep 22 07:02:12 EDT 2006 | basem
Thanks Rob. Our concern is placing tiny components side by side at a minimum pitch, along with fairly large BGAs and TSOP2, which are themselves, having small to fine pitch leads. yes, accuracy in placement in our application is crucial, yet, what i
Electronics Forum | Tue Oct 09 13:07:35 EDT 2012 | ericrr
Yes I wondered that myself for the Juki pick & place machine, then I noticed the default value when doing the "pick tracking" is 5 so I am left thinking why not use that value. So when you introduce a new reel the value comes up "5, feeder position"
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Electronics Forum | Thu May 05 19:13:33 EDT 2016 | darby
Thanks Sr. If you have zero tolerance for simul pick up in your component files then you will not have simul pick up due to variances in your head offsets. So you are saying that on your Juki you run a tolerance for 0201? All other head positions at
Electronics Forum | Wed Aug 10 09:56:09 EDT 2022 | jojoled
Hi guys, from certain time (not sure, but it could be power down last week) none of the 2 heads can succesfully pickup nozzle from ATC (after startup calibration is done, but in the calibration sequence the ATC height is not measured, it just calibra
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Wed Mar 18 07:56:43 EDT 2009 | cyber_wolf
You can calibrate it until you are purple in the face. Job to job and part to part they are just not consistent.They either fail parts or put them on skewed. I have gone back and fourth on this for(10+) years. We have had Fuji look at it and we have
