Electronics Forum | Fri Aug 26 03:49:17 EDT 2005 | aj
Mark, Is there really that much to a CP43 feeder that its worth the hassle of making a "calibration jig". Train your Operators properly and that should do the trick I have a CP43 and Reject rate runs at
Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Mon Dec 04 23:57:44 EST 2006 | Tom Scherer
HEllo, I was wondering if you have any information where I can obtain a used fuji feeder jig? I am looking for the simole one with no screens or anything, just the simple one.PLease advise?? Tom Scherer Control Products Inc. 763-213-3302
Electronics Forum | Wed Dec 20 07:04:13 EST 2006 | cyber_wolf
Is there anyone out there using the Alternative SMT jig ? http://www.alternativesmt.com/productdetail.asp?p_id=2
Electronics Forum | Mon Aug 17 13:47:25 EDT 2015 | dlee87
Does anyone have a Fuji CP7 or CP6 feeder calibration jig manual that they would like to share?
Electronics Forum | Sat Mar 28 06:45:31 EDT 2020 | aswa1111
Hey everyone, I hope all of you doing well this time of the year. We have an old Juki / Zevatech 740 pick and place machine and we got a problem with the vision alignment, every placement is off by 2mils. How can you run an offset calibration on t
Electronics Forum | Tue Sep 15 08:50:42 EDT 2009 | babe7362000
Just wanted to know if the Juki Feeder Calibration Jig is worth purchasing? Pros and Cons?
Electronics Forum | Tue Sep 15 12:53:17 EDT 2009 | cyber_wolf
We have never needed to calibrate a juki feeder.I have been told that Juki will loan the jig out. Calibrate all of your feeders and send it back....?
Electronics Forum | Sun Mar 10 16:16:35 EDT 2019 | sam512bb
Good day All, I was curious if anyone has a source for Juki/Zevatech PM575 Calibration jigs? My machine's placement is off and various a bit and so it was recommended to calibration the laser alignment. Sadly, there are no service centers located a
Electronics Forum | Mon Dec 02 13:53:19 EST 2019 | alexeyzb
Old GC-60D is risk of failure. So Juki is more easy for repairment. For example juki has one calibration jig for head with machine but for GC-60D head you need very expensive KIT (or you need to buy service).