Electronics Forum | Thu Nov 04 15:11:05 EDT 2021 | azdback
I have an ASYS conveyor that I repaced the motor conmtroller AMC 4-2 with a used one.( Old one lost all power) The used one is in German, and I have not been able to figure out how to change the lenguage to English. This particular conveyor has a mo
Electronics Forum | Fri Apr 12 17:35:54 EDT 2013 | buckcho
Hello, try loosing up the belt. If they are too tight it can cause the conveyor to run slowly or even to damage the motor.
Electronics Forum | Tue Apr 16 13:01:10 EDT 2019 | slthomas
Is it possible that the conveyor controller card has the capability to switch direction with something simple like a jumper shunt?
Electronics Forum | Tue Apr 16 13:32:36 EDT 2019 | slthomas
Another question: After the conveyor starts running, when you trip the sensor at the other end, does it stop running?
Electronics Forum | Tue Apr 16 19:59:32 EDT 2019 | davef
Tel: 0115 955 4506 Kinetic Conveyor & Roller Systems Unit 2 Enterprise Park Wigwam Lane Hucknall Nottingham NG15 7SZ Email: sales@kineticbelting.co.uk
Electronics Forum | Wed Apr 24 21:45:33 EDT 2019 | aksaustin
If you look in the back of the panel there should be some type of VFD drive that controls the conveyor motor. You may be able to control rotation that way depending on the manufacturer. Should be able to google the VFD mfg and find a manual online,
Electronics Forum | Mon Mar 26 09:41:03 EDT 2018 | fuji_user_2014
Hi Gurus, Looking for alternatives to line makeup after reflow oven. Currently, I have a continuous on flat belt conveying out of my reflow oven straight to an EOL bench. The operator manually picks up the board off the belt (there is a roller at t
Electronics Forum | Fri Apr 12 18:10:57 EDT 2019 | davef
Here's what we've done in the past. Depending on how it's configured, conveyors can run either forward or backward, but only in one direction at a time. The voltage polarity through the starter of the drive motor configures the direction. So, swappin
Electronics Forum | Sat Mar 25 06:07:41 EDT 2023 | smtusa
The part that sticks out in the rear for conveyors can that be removed if running in manual pcb loading only?
Electronics Forum | Wed Dec 28 18:09:47 EST 2022 | atpico
Second question concerning MPM UP2000HiE: Are there two options of conveyor lengths for this printer? Looking for conveyor belts spare parts I found two options: One 137" and one 106" that gives about 134 and 174cm total conveyor lengths. Does any