Electronics Forum | Fri Aug 14 12:31:07 EDT 2020 | cyber_wolf
Wellman Rau, Do you offer kielbasi processing equipment ? Please send me a quote. We can pay in Amazon gift cards.
Electronics Forum | Mon Jan 15 13:49:09 EST 2007 | leemeyer
Hello all, I am having some trouble with the conveyor speed on an Omniflow 7 reflow oven. Recent profiling showed that the conveyor was running to slow so I calibrated the speed using the instructions in the manual. After calibration there was no ch
Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer
This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to
Electronics Forum | Tue Oct 09 20:30:25 EDT 2001 | djarvis
Thank you all for your input. We didn't get the oven and if we did I decided in the short term to just turn it around and run it as a belt mesh oven - the next line we buy runs it's conveyor to suit the oven. Hi to you Marc, it's been a few years. Yo
Electronics Forum | Wed Jul 15 03:17:47 EDT 2020 | wellmanrau
We have been producing the SMT machines and intelligent equipment for many years, integrated Design, R&D, Production, Sales and Technical Service. What products we manufactured are: SMT Printer/Stencil Printer/Solder Paste Printer, Pick and Place Mac
Electronics Forum | Sat Aug 15 20:20:37 EDT 2020 | ddfreeze
need the dimensions for a MPM#P2604 conveyor belt
Electronics Forum | Thu Mar 04 23:01:11 EST 2021 | tomek_k
P2604 BELT,CONVEYOR,.25" X105.25"L Regards Tomek
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Tue Oct 09 11:42:42 EDT 2012 | cyber_wolf
Actually the correct way to fix this is to carefully remove the belt on the rear of the machine that connects the left and right rail lead screws together. Square the rails then carefully re-install the belt *without turning either of the lead screws
Electronics Forum | Mon Oct 08 13:31:50 EDT 2012 | highmillr
Yeah thanks swag, I do that ridiculous routine about every morning....im over it.... so I ordered a new belt..4 weeks lead time by the way from speedline. AND,...I took the tiny belt tensioners on each side and tightened both pretty tight and