Electronics Forum | Wed Nov 23 19:24:04 EST 2022 | proceng1
Is there an IO screen so you can see what sensors are tripped?
Electronics Forum | Tue Feb 15 19:48:43 EST 2022 | mihai_voivod
Thank you for the answers. All the wheels are spinning. I have attached a video of it popping off. I need to count the spacers on a track that doesn't pop off and compare.
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too
Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Thu Feb 17 16:25:20 EST 2022 | mihai_voivod
I'm not understanding what roller with closed sides you are referring to. My edge roller bearing (brass color) has a lip on the side. The middle roller bearings (silver) have a slightly bigger lip. These are the roller bearing shown on the manufact
Electronics Forum | Tue Dec 16 16:14:20 EST 2003 | Bill
We are in need of a replacement conveyor belt for an unload-end conveyor(post wave solder). The part number we had at one point (formerly PCT automation) was 65-4008-4 (Belt, Flat-W=23.75 L=171.70) green high temp conveyor belt. Any help would be g
Electronics Forum | Wed Dec 17 13:04:37 EST 2003 | Bill
Thanks for the information, --We would like to replace the conveyor 'belt' rather than replace the whole conveyor. Do you know of any sources for the belting material? (ESD, heat and chemical resistant) Best Regards, Bill
Electronics Forum | Wed Dec 17 14:08:42 EST 2003 | davef
Really, they wouldn't sell you just the belt??? Wow. Oh well, there was a SMTnet Thread on conveyor belts within the past 3 months. Search the fine Archives.
Electronics Forum | Fri Dec 19 10:15:24 EST 2003 | haviland
Bill--Good morning. We have several decline conveyors w/ conductive black belt Plus cool down units w/ banks of (8) fans. I believe the belt widths are 18". Would that work? Everything is in Illinois. Thanks, Nick Haviland, Electronic Assembly Machin