Electronics Forum | Wed Dec 22 12:01:27 EST 2021 | cuervo
hello i have a juki 2060 an a error E620001 EMERGENCI STOP appears on screen an there is no switch pressed can someone help me , my pick and place is dead
Electronics Forum | Thu Aug 12 06:46:35 EDT 2021 | bukas
there is no, error $0022 in technical reference. is the error you are getting a EMER level? if so there is probably a safety sensor or switch that is causing this error. $0021 is related to door switch so I would go from there. do you have technical
Electronics Forum | Wed Mar 13 19:48:31 EDT 2013 | marcelorotofrance
The front door has as security switch, indeed. It works ok. A lever switch for override the door switch is also included from factory. (It don´t look good from the safety point of view but, you know). There is also a presostatic switch on the air reg
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
Electronics Forum | Wed Jul 09 05:06:52 EDT 2014 | bobpan
Are you sure you don't have a door interlock problem? Some of the covers of mirae machines have a physical switch and a magnetic switch that both have to be made for the interlock to be closed. It could be if you have a magnetic switch that the magne
Electronics Forum | Thu Aug 29 05:01:38 EDT 2013 | bobpan
Motor Error 5 is usually an interlock error. Take off the rear right cover and look at the red and green led's on the driver cards. If they are both lit....you have a door open or if you have carts....a feeder base switch is up. Good Luck
Electronics Forum | Thu Apr 03 12:36:30 EDT 2014 | jimmyboz
Hold the F1 key during power up, it will boot into the I/O screen. Check the 3 photo zones. Check the door switch. In the main screen you can cancel D1 or D2, then you can swap light sensors. Check carefully the wiring, there is a SYNC wire betwee
Electronics Forum | Tue Oct 20 12:02:47 EDT 2015 | cbeneat
I have never encountered that particular problem. Have you checked the door switches in the I/O to see if one is actually open? Another thing I have encountered is grease getting on the linear scale which will give you errors that are false. I wou
Electronics Forum | Wed Feb 28 14:48:41 EST 2007 | jax
I doubt it's the board house. Check the Laminate being used. When you find out that the laminate is IS410, search the forum for time and location for the next "RoHs Compliant PCB Delamination Support Group" Some of the locations are hard to find but
