Electronics Forum | Wed Nov 23 19:24:04 EST 2022 | proceng1
Is there an IO screen so you can see what sensors are tripped?
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Fri Feb 01 12:52:31 EST 2013 | ericrr
Interesting enough, it did turn out to be alignment, maybe the machine is getting bend & twisted just like people do when they get old....... or maybe I should say as the beam gets less intense with old age the sensor needs to be readjusted to pick u
Electronics Forum | Mon Nov 21 15:52:21 EST 2022 | crystalw4280
The internal conveyor stopped working...won't take board in. Says there is a board inside machine...is it a sensor problem? Any suggestions? Nothing led up to this. Just started machine up after weekend, and it will not take the board in.
Electronics Forum | Wed Nov 23 19:08:20 EST 2022 | leeg
You should be able to check the sensor, most had have the red light to indicate that a PCB is being detected. Depending on the version of software it should tell you within the manual control option too
Electronics Forum | Thu Nov 24 01:21:42 EST 2022 | crystalw4280
The bottom piece of the sensor broke, and it threw it off, fixed now. Wasn't sure, it must have come loose enough to throw it off, but not enough to trigger an error that it wasn't working...because it was still in the casing
Electronics Forum | Thu Sep 14 06:18:00 EDT 2023 | deniseburton
Hello, mcdvoice It seems like your Juki RS-1R machine's laser height calibration may be off. When measuring a 0402 resistor, it consistently reports heights around -0.60 to -0.70, causing pickup issues during production. Manually adjusting it to -
Electronics Forum | Thu Apr 05 10:03:28 EDT 2018 | roblackey
Lasers can go quite often, but if you are lucky and not in a great hurry you can get them refurbished dirt cheap. If you have a good 750/760 that has been well maintained it should run for a long time, but if it has not been loved you can end up payi
Electronics Forum | Sun Sep 15 04:45:22 EDT 2013 | jandon
Cleaning and lubrication requires maintenance training. You can really break something if you don't know what you are doing. For example you can break your expensive rubber nozzles or cameras with inappropriate cleaning. Check: - Piping and joint -
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
