Electronics Forum | Tue Mar 04 10:36:10 EST 2014 | charliedci
We have a KE2060, 2080 and an older 750. All of these use same feeder trolleys. I presume the 2020 and 1070 also offer same trolley compatibility. If machines are not set up for trolleys, you will need conversion kits to utilize trolleys, which sho
Electronics Forum | Thu Feb 27 15:21:37 EST 2014 | idscraigsmith
My company uses a Juki KE-2020L and a Juki KE-1070L pick and place. I am trying to locate feeder trolley's with feeder banks that would be compatible with these machines but am having a hard time finding anything. Anyone have suggestions of where t
Electronics Forum | Fri Feb 28 03:13:16 EST 2014 | smtspareparts
Craig,we just make juki cf/af/ff feeders,but hasn't encountered such problems,perhaps I did not very understand the intention,normally install reels on proper feeders,and install feeders on proper position of feeder trolley,but you want realize more
Electronics Forum | Thu Jun 18 15:04:32 EDT 2015 | empac
We have Juki 2000 series feeder carts. Let us know if you have any interest. Thanks.
Electronics Forum | Sat Mar 25 16:27:51 EST 2006 | Frank
I would rather keep my Juki KE-2060. It runs faster, do larger boards, and can place a wider range of components when compared to the Opal. Also, I have trolleys on front and rear, without losing any feeder locations. Why can't you put trolleys on
Electronics Forum | Mon Aug 01 08:54:39 EDT 2022 | spoiltforchoice
You should get good service support and reliability from all of them, provided your local distribution agent is a good one. In the UK for instance I would trust all 3 on that front but I would expect very different support pricing structures. Any ma
Electronics Forum | Wed Mar 29 03:40:06 EST 2006 | Frank
The Juki 2060 can have both front and rear trolleys and you do not loose any feeder locations. My question was why can't the Assembleon put trolley on the rear? I recently visited a friend at a company that used a lot of Assembleon and compared run
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.
Electronics Forum | Thu Dec 14 04:02:40 EST 2017 | spoiltforchoice
"I would expect that any intelligent feeder > enabled machine would pull the correct part no > matter where it is placed on the machine (not > forced by the program)" > > this is true, but you > have to tradeoff the setup time vs production > t
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
winsouce.jpg)
