Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Wed May 12 23:33:04 EDT 1999 | Matt
WARNING: This is a plug. I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" Well I have written w95/database code that reads FUJI output files (CPII,CPII,IP2 etc) and d
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Thu May 13 00:34:49 EDT 1999 | Jeff Sanchez
| WARNING: This is a plug. | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | Well I have written w95/database code that reads FUJI output files (CPII,CPII,IP2
Electronics Forum | Thu May 13 09:41:25 EDT 1999 | Chrys Shea
| | WARNING: This is a plug. | | | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | | | Well I have written w95/database code that reads FUJI output files (CPII
Electronics Forum | Thu May 13 21:22:27 EDT 1999 | Matt
| | | WARNING: This is a plug. | | | | | | I have read post on this site where the question is raised: "My machine can do 80 units per hour, but I am only getting 35 - WHY?" | | | | | | Well I have written w95/database code that reads FUJI output f
Electronics Forum | Mon Oct 08 14:48:54 EDT 2018 | tey422
Need help on how to fix or temporary fix to bypass the "Rear feeder bank in lower position" error for the Juki 2080 machine. Even replace with different feeder bank won't fix. Any suggestions?
Electronics Forum | Fri Jan 28 15:22:07 EST 2011 | dougt
The PLC240-AK is an IC on the stepper board used to control all the stepper driven axis. I don't remember which axis are driven by stepper motors, possibly the table (x axis). Which axis acts wierd or doesn't move when you home the machine?
Electronics Forum | Fri Mar 22 13:32:15 EDT 2019 | kahrpr
all the motors on the head are the same just the connecting cable are different length. the motors have a home position for the zero pulse that home position has to match when the flag passes through the homing sensor all servos have a home position
.gif)
