Electronics Forum | Fri Mar 09 11:09:56 EST 2018 | reckless
Most likely I am doubling the budget mostly because of the feeders. I am leaning to Juke 750/760. Most likely will end up buying 2 of them once we are fully up and running and understanding everything. We are looking for a good old dinosaur who
Electronics Forum | Sun Aug 04 19:42:50 EDT 2013 | starlogixs
Thanks for the reply Sarason. The software looks interesting, as we are a small manufacturer. However I do need the original Juki software for a calibration file. The X axis motor has been replaced but the calibration file is missing to teach and ca
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Tue Jun 23 08:08:38 EDT 2009 | ptxems
We have a couple of Zeva/Juki PM570L's. One machine has developed a fault with the z axis motor. It is continually 'buzzing', we have checked and there is 24VAC on it. Although even on the other machine there is AC voltage on the motor. We have sw
Electronics Forum | Mon Sep 03 07:17:43 EDT 2018 | oriolsancheza
Hello everybody, For a long time the Juki has been not used, but was working fine before that. Since 4 or 5 month ago, it brings some problems when initializing with T and Z Axes. Till now, just powering it off and on for a few times worked, but no
Electronics Forum | Mon Aug 01 10:31:34 EDT 2022 | spoiltforchoice
I'm not familiar with the machine, but isn't a KE760L an old slow "single head, single gantry" two spindle machine? Any speedup from simultaneous picking would not necessarily be that much of an improvement. Setup as you described is the way I would
Electronics Forum | Sat Apr 28 21:13:11 EDT 2018 | stephenj37824
So lots of quotes and research later we have eliminated a few added a few to our choices lol. So it looks like we will be doing a decent volume now (due to our other board supplier letting us down as well). Roughly 4-5 million leds/connectors per mon
Electronics Forum | Mon Mar 19 21:55:23 EDT 2018 | stephenj37824
You've got (to my mind) 3 wholly different > classes of machine there. > > Essemtec is upper > entry level maker that is increasingly > differentiating itself from the competing > machines in its class by focusing on 3d > assembly/dispensing op
Electronics Forum | Sun Mar 18 17:46:10 EDT 2018 | spoiltforchoice
You've got (to my mind) 3 wholly different classes of machine there. Essemtec is upper entry level maker that is increasingly differentiating itself from the competing machines in its class by focusing on 3d assembly/dispensing options. The Puma als
| 1 |
