Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Mon Aug 24 17:05:51 EDT 2020 | kumarb
Aurash, we own Yamaha machinery but just throwing it out there...are the movements of the motors smooth or with friction? Is it possible that the linear screw rods (as in our machinery) require to be lubricated? There are special lubricants for each
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Mon Aug 01 10:31:34 EDT 2022 | spoiltforchoice
I'm not familiar with the machine, but isn't a KE760L an old slow "single head, single gantry" two spindle machine? Any speedup from simultaneous picking would not necessarily be that much of an improvement. Setup as you described is the way I would
Electronics Forum | Mon Sep 03 07:17:43 EDT 2018 | oriolsancheza
Hello everybody, For a long time the Juki has been not used, but was working fine before that. Since 4 or 5 month ago, it brings some problems when initializing with T and Z Axes. Till now, just powering it off and on for a few times worked, but no
Electronics Forum | Wed Sep 05 06:34:08 EDT 2018 | oriolsancheza
Hi Rob, Thanks for your fast response. In fact, after a better look to driver boards, it has leaking SMD Electrolityc caps. Unfortunately after replacing them in 3 units, one of them gives 90% of times, ALARM4 led ON. Looks like a comunication pro
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-
.png)
