Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Thu Sep 15 13:55:31 EDT 2022 | jojoled
Hi all, I need help with problem Iam stuck with JUKI KE760L. -SERVO ALARM 1 and ALARM4 https://photos.app.goo.gl/CCDcNtbbEhJLBo47A Sometimes I do get error ON ALL 4 SERVO drivers (1-2seconds after starting the calibration routine (even before the Z
Electronics Forum | Fri Apr 02 14:21:58 EDT 2021 | sacd
deleted
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Mon Sep 05 11:51:30 EDT 2022 | jojoled
Can anybody help with Re-calibrating the Z-axis height in MS parameter , on JUKI KE760L? In MS parameter manual, there is information that these accessories are needed to recalibrate the Z-axis , can anybody tell where to get them, or ideally how to
Electronics Forum | Mon Jul 05 11:16:50 EDT 2021 | aurash
Not sure if you fixed the problem in the meantime but try to disable the Z4 head to see if the problem actually belongs to the 4th head. Sometimes a totally unrelated problem is manifesting on the head. (I had communication problems between the XMP c
Electronics Forum | Thu Aug 20 19:30:45 EDT 2020 | aurash
Hi Guys, I 'm having trouble with a JUKI KE2060 - multiple errors on Z, X, Y axis (it seems that the problem moves around) - the error codes are E602137 E603112 any help or an electrical diagram of the machine are highly appreciated A
Electronics Forum | Mon Sep 03 07:17:43 EDT 2018 | oriolsancheza
Hello everybody, For a long time the Juki has been not used, but was working fine before that. Since 4 or 5 month ago, it brings some problems when initializing with T and Z Axes. Till now, just powering it off and on for a few times worked, but no
Electronics Forum | Sat Aug 26 21:53:47 EDT 2017 | kieren
Hi Everyone. I am looking for some help with my Juki Ke750. The problem is that after booting up and then starting the home position function I receive an error as stated below Message File Error E0000: KEY=200078 STATUS=2 C:￥X750 ￥GX3ERROR。MSG
Electronics Forum | Mon Aug 31 09:16:54 EDT 2020 | aurash
After reading the machine logs it seems that the problem is on the X-axis but the safety mechanism is disabling all the Servos and the Axis system (all axes) are in error state (that's why the error messages are showing on different axes) The JUKI m
.gif)
