Electronics Forum | Tue Jan 03 03:01:35 EST 2006 | Frank
The 740 and 760 basically have the same specs as far as component ranges: 0402-50mm components. The 760 is a bit more accurate and the vision system is better. The 740 was designed when BGA weren't really around and so it can barely vision center b
Electronics Forum | Sun Aug 29 12:29:37 EDT 2021 | jojoled
Hi, can anybody provide a Installation software for JUKI KE/FM760L,named as "Juki Flexible mounter 1.35 " or similar version? I need to change the PCB max.width limit from 410mm to 560mm(heads can travel that far, no problem) and on disk the MSDOS so
Electronics Forum | Fri May 06 06:54:56 EDT 2022 | jojoled
I have JUKI KE760L, and did notice that, when In "Feeder data " I select feeder position say 20, it enters XYZ coordinates for "pick coordinates" for example X=-260, Y=-25, Z=-1, which I need to "correct always by camera (it is slightly shifted).....
Electronics Forum | Fri Jul 29 06:48:11 EDT 2022 | jojoled
I have old JUKI machine, which after power loss seems to have corupted configuration file(all works fine,except Vision configuration for fiducial recognition : camera is unable to read/ write parameters for Vision), can anybody help to tell which fil
Electronics Forum | Sat Aug 13 23:41:31 EDT 2016 | sarason
Download PCBSynergy which is located here. http://members.iinet.net.au/~sarason/ It has outputs for the KE750,KE760 and 2080 from Juki It will read a large number of CAD formats. Including Altium PCBDOC, and Protel PCB and all the variants inbetwe
Electronics Forum | Wed Apr 27 03:19:21 EDT 2022 | jojoled
Hi, bought older yet good JUKI machine, but can not make it work, due to lack of explanation of PWB editing details in manuals, hopefully someone can help : - what is BOC mark - how is the "PWB centering pin" normally used? - What is "Hole reference
Electronics Forum | Fri Jul 29 11:31:44 EDT 2022 | jojoled
Hi Guys, I have Juki PnP machine with 2 heads, and for some reason, whatever I do, I can not make the machine to use 2independent feeders for parallel picking up single component reference by both heads from 2 feeders. Example , imagine you have a
Electronics Forum | Wed Aug 10 09:56:09 EDT 2022 | jojoled
Hi guys, from certain time (not sure, but it could be power down last week) none of the 2 heads can succesfully pickup nozzle from ATC (after startup calibration is done, but in the calibration sequence the ATC height is not measured, it just calibra
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
1 |
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830