Electronics Forum | Thu Dec 18 14:38:58 EST 2014 | rangarajd
Hello, I don't have any experience with Juki. Visited one of their booth recently and I was told they use a laser for alignment. How does this work? Is there any advantage over the traditional vision alignment? Thanks!
Electronics Forum | Fri Dec 19 12:43:01 EST 2014 | emeto
I had some of these before and they do a decent job. Laser alignment is ok for passive components. Compared to vision systems it has mainly disadvantages. If you have bended lead on IC for example, it wouldn;t catch it and it will place the part. I w
Electronics Forum | Sun Dec 21 23:30:09 EST 2014 | sarason
Since the Laser alignment bit is attached to the head and you don't have to move the part to a camera location, before placing the component on the board it is about the fastest method there is of getting accurate component alignment. With more moder
Electronics Forum | Wed Jan 09 14:43:28 EST 2019 | SMTA-Andy
Would like to get feedback on realignment of an SMT line with loader/unloader, printer, p&p and 16' oven. What tech would be good to use if doing it ourselves? (Lasers, etc?) What companies can be recommended for a professional job?
Electronics Forum | Wed Feb 01 06:52:36 EST 2017 | cyber_wolf
Has anyone had any success polishing scratches out of a Juki laser ? If so, how did you do it ? Thanks in advance
Electronics Forum | Fri May 05 02:22:39 EDT 2017 | beckysu
Our company supply repair service for JUKI lasers, sorry for disturb you, may you need it in the future. Have a nice day. Best Regards, Becky Su becky(at)hysmt(dot)cn
Electronics Forum | Fri Aug 07 13:03:53 EDT 2020 | assuredtech
SMT Forum, Does anyone know if the Sanyo laser alignments can be replaced with the Cyberoptics brand? If so is it plug and play or does it require any software or machine configuration changes. Thanks in advance
Electronics Forum | Wed Jul 16 19:38:28 EDT 2014 | garym4569
What is the base cost of an inline pcb etcher? Specs: fiducial alignment, smema interface, 400mm x 400mm marking area. Will be used to mark panel 2d codes, pcb array 2d codes, and human readable. Thanks Gm
Electronics Forum | Wed Feb 01 07:36:09 EST 2017 | rob
We use a place in China that refurbs them cheaply, PM me and I'll send you the details. Did we have a little feeder crash by chance?
Electronics Forum | Wed Feb 01 07:59:35 EST 2017 | cyber_wolf
Hi Rob, Thanks for the response. I am not aware of any feeder crashes. We aren't real sure where the scratches came from. They do not appear to be too deep but are at the edge of acceptable. We are still up and running. I don't think I am comfortabl
