Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim
Electronics Forum | Fri Feb 28 03:13:16 EST 2014 | smtspareparts
Craig,we just make juki cf/af/ff feeders,but hasn't encountered such problems,perhaps I did not very understand the intention,normally install reels on proper feeders,and install feeders on proper position of feeder trolley,but you want realize more
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Wed Nov 20 15:03:27 EST 2019 | richardcargill
If you've formatted the pcmcia / CF card then it'll be blank and have no DOS or anything as it acts as the hard drive for the machine. A DOS diskette formatted with /S will boot from the floppy drive, then allowing software installation with the orig
Electronics Forum | Tue Feb 21 06:49:41 EST 2017 | carlos350
Hello friends, I'm having a problem with a juki ke-750 when I connect it, I do not know the origin of it, but try to show it at the beginning, but then right away, it's the process that may be somebody please.
Electronics Forum | Sat Jun 07 23:37:34 EDT 2014 | demzvill
Hello all Good morning. I just want to ask with you guys about the problem that we always experienced in our production. We could not get our target ppm due. to inverted placement of chip resistor. We are using 2000 series juki mounter and cf03hp j
Electronics Forum | Wed Mar 01 13:57:41 EST 2017 | sarason
Try to rephrase your question so we can understand your it. regards sarason
Electronics Forum | Fri Apr 02 14:21:58 EDT 2021 | sacd
deleted
Electronics Forum | Sun Aug 04 19:42:50 EDT 2013 | starlogixs
Thanks for the reply Sarason. The software looks interesting, as we are a small manufacturer. However I do need the original Juki software for a calibration file. The X axis motor has been replaced but the calibration file is missing to teach and ca
Electronics Forum | Wed Oct 03 15:43:24 EDT 2018 | gpascolla
We have a Juki FM-740 that we just received that will boot up fine when it wants to origin the servo drive does not engage. Nothing lights up but I do have power to all 3 units (X, YL and YR).
