Electronics Forum | Tue May 14 18:07:27 EDT 2002 | soupatech
My method is not good if accuracy is an issue. Most of our reels come with a guage on the back. It is not a perfect count but with a good eye you can get within a couple hundred on reels of 5k. On the reels shipped with no guage I usually just hold a
Electronics Forum | Tue Sep 18 10:52:14 EDT 2012 | sarason
Sounds like a plan. The usual way is to count how many you use on the job either by pre-calculation. Or how many clicks the machine counts and save the data before switch off, then drop it back into a spread sheet. This depends very much on the mach
Electronics Forum | Mon Aug 20 07:17:36 EDT 2012 | ericrr
Hi we have Juki KE-750L's is there any program to work out how many parts left on the reel, on the machine, the placement program does have a option to keep this number, but once you finish the run and start a new run the figure is lost. Unless I mis
Electronics Forum | Thu Dec 03 17:50:29 EST 2009 | jesalinas47
This happens on the counting area which it is into warehouse , we are looking for a poka yoke to avoid delivering reels with a wrong quantities , the question is : have you implemented any poka yoke in your warehouse ? how it works ? I could suggest
Electronics Forum | Wed Aug 22 11:30:28 EDT 2018 | robl
Hi, we use QY-SMT for our Juki & Yamaha feeders and spares. Great service. Eric Wu sales@qy-smt.com Used them for 6 years.
Electronics Forum | Wed Jun 25 18:48:57 EDT 2003 | russ
How about using one of those ESD sprays that apply a dissipative coating? Tech Spray has one that is supposed to be permanent. It is called LICRON. Russ
Electronics Forum | Tue Jun 24 17:41:29 EDT 2003 | MikeF
I'm looking for an esd safe tray, something like what pharmacists use, that we can use to count out loose parts. Has anyone seen something like that? We have a lot of part values in our stock room that have maybe 100 or so loose parts in a bag. The
Electronics Forum | Wed Jun 25 10:29:32 EDT 2003 | caldon
Hey Mike- We ran into the same thing when we purchased a Large CanadianManufacturers repair business. We were creative and first used an ESD bag cut open (Simulate the paper idea) then we used a 3M parts bin and would tip it on its corner to funnel t
Electronics Forum | Mon Jul 11 10:48:48 EDT 2016 | mnorthey
I have experienced this problem on a number of different machines and have found that it has been one bad nozzle causing the problem. We run Juki 3010 and 3020 and occasionally we have had similar problems. One question, is it bad placements on all 6
Electronics Forum | Wed Aug 22 07:24:34 EDT 2012 | ericrr
how about this for resistor & capactors with 4mm pitch, all measurements in millimeters. cell A1 "Input inside diameter" answer in cell B1 cell A2 "Input outside diameter"answer in cell B2 cell A3 "Input layer width,(from inner to outside layer) (no
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
.gif)
