Electronics Forum | Wed Mar 23 13:19:40 EDT 2011 | bwjm
Charlie, thanks for the reply. But I am still unclear with the machine capabilities. Does the standard ke740 able to place 01005 components or is it the machine was upgraded to place 01005? This is my first time getting a placement machine, I am quit
Electronics Forum | Wed Mar 23 18:02:31 EDT 2011 | fredc
Hello Scott, We have sold modified 101 nozzles. They had a .25mm hole instead of standard. The customer ordered these for placing 0201s. Is it possible they were used on the 740 machine? Or maybe the 760? FredC
Electronics Forum | Thu Mar 24 10:47:59 EDT 2011 | bwjm
So if i purchase the modified nozzle, am i able to place 0201. How about the vision accuracy of machine. I'm quite confused now....... Between, Scott is there anything that i have to pay special attention when i pick my machine up, any advices? THa
Electronics Forum | Wed Mar 23 11:48:11 EDT 2011 | charliedci
bwjm, We have placed 0402's with 740 and it worked well. When new (if 1005's existed then) maybe, but that sounds like a seller/manufacurer quoting specs. I would think all 740's being used are well used, so placement accuracy might not be per mac
Electronics Forum | Wed Dec 22 12:01:27 EST 2021 | cuervo
hello i have a juki 2060 an a error E620001 EMERGENCI STOP appears on screen an there is no switch pressed can someone help me , my pick and place is dead
Electronics Forum | Tue Jul 12 08:54:34 EDT 2016 | leeg
well there you go. I found that trying > different values in the "Placing Stroke" had a > big effect. I changed it to 2mm and it placed > them well, but I could see the board also flexing > a little, went to 1mm and the problem came back, > so
Electronics Forum | Mon Jul 11 13:21:40 EDT 2016 | bradholland
well there you go. I found that trying different values in the "Placing Stroke" had a big effect. I changed it to 2mm and it placed them well, but I could see the board also flexing a little, went to 1mm and the problem came back, so have sat in th
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Thu Nov 10 23:43:33 EST 2022 | sarason
Are you using the correct nozzle for 0402? Cant remember the number OTTOMH but 501 rings a bell. somewhere I have the table, it is in the Juki service manual IIRC. This would explain placing all others okay but 0402 is not very good , Senoirtech is c
Electronics Forum | Tue Nov 08 22:49:41 EST 2022 | jojoled
Hi, I need help with placing 0402 resistors 90% of them are picked correctly, but are not placed(thrown away) giving me error : LASER retry over. Slightly higher varistors in same package have slightly better placing rate, about 50%, but still not su