Electronics Forum | Thu Jun 30 18:31:28 EDT 2005 | KEN
Make sure your RS232 is screwed in and not loose. Verify your PC is not hanging up and locking up the com port (windows can really suck some times). I would scan-disk and defrag. I bet its not a furnace problem, but a PC problem.
Electronics Forum | Sun Sep 18 20:42:37 EDT 2005 | Ken
Link Fail is the RS232 connection to the FCU. I would check the connector, cable that plugs into the computer. Verify all power supplies are working. The most likely scenario is this: Computer malfunction Cable / connector issue. Defecive FCU
Electronics Forum | Wed Feb 01 08:18:28 EST 2006 | slaine
RS sell a heat cun that is fully temperature adjustable buy one of them and pre set it to the right temp then put a calibration sticker over the control.
Electronics Forum | Wed Jan 17 05:54:53 EST 2007 | imounen
i would like to know if an ICT can test my communication circuit based over RS485 and over optical communication((DO))optical head for counting circuit.
Electronics Forum | Mon Jan 21 11:47:03 EST 2008 | babe7362000
We have a Contact CS400D 1991 series and when I press Control H, it gives me a host error. I can not get it to communicate with the RS232
Electronics Forum | Tue Feb 20 09:46:08 EST 2018 | dekhead
Somewhat vague on error message; obviously has to do with RS Table travel (making sensors at anticipated time) but need to know timing of error incidents and specific error.
Electronics Forum | Mon Apr 15 12:36:04 EDT 2019 | robl
We found the blowers were usually fine, but the capacitors strapped to the blower motors were failing. They were under $5 each from Digi/Mouser/Allied/RS. Worth keeping a few around. Last place had 12 Hellers including a 1500 doing ROHS with no is
Electronics Forum | Wed Jun 19 11:26:06 EDT 2019 | key
We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.
Electronics Forum | Thu Jun 27 10:51:59 EDT 2019 | key
Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.
Electronics Forum | Tue Mar 16 14:09:04 EDT 2021 | sarason
Looks like a hirose connector. Is it RS232or a combination VGA and kb interface? sarason