Electronics Forum | Sun Nov 13 14:20:23 EST 2022 | crystalw4280
Thank you. I will definitely remember this for next time.
Electronics Forum | Mon Nov 14 14:42:11 EST 2022 | cyber_wolf
Air pressure has nothing to do with that error.
Electronics Forum | Fri Nov 11 14:26:15 EST 2022 | crystalw4280
Error about 'nozzles cannot be returned' why is this happening in middle of a run...? What can we do to resolve this
Electronics Forum | Fri Nov 11 21:37:35 EST 2022 | daveyk
I've seen this error multiple times. Possible that there is a part still attached to the nozzle or the machine thinks that there is and sometimes it doesn't display the window with the commands to trash the part.
Electronics Forum | Fri Nov 11 21:38:50 EST 2022 | daveyk
Also, think about when the last time someone removed a nozzle and possibly didn't put it away in the proper location.
Electronics Forum | Mon Nov 14 03:48:18 EST 2022 | frankchan
Maybe also check the air pressure, the lack of air pressure could also sometimes make the head lose grip on the nozzles
Electronics Forum | Tue Nov 15 00:33:42 EST 2022 | frankchan
That is right, air pressure would be a higher level of malfunction and reported on the main screen, maybe also try maintenance of the head, cleaned up and oiled them, anyway I'm speaking of experience based on the old days when I using the Fuji serie
Electronics Forum | Mon Jun 16 22:04:44 EDT 2025 | mrprice
error e601040 on the juki smt (failed to recognize calibration block mark.(occ) When I start the device, in the reference mode (in device startup mode), the laser calibration section gives this error. And it does not display a fixed point on the mon
Electronics Forum | Tue Aug 05 04:53:02 EDT 2025 | demurerecall
That sounds frustrating--I've seen that E601040 error before, and it usually points to an issue with the laser not being able to detect the calibration block mark. If it's not showing a fixed point on the monitor, it could be due to a dirty lens, mis
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( Loader/Unloader,SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
