Electronics Forum | Thu May 22 16:16:05 EDT 2008 | rmitchell
Hi, Our MY19 will not advance our slot 2 feeder in all tape and reel LM magazines. Other slots advance fine on the same magazine but #2 will not, no matter where we position the magazine along the machine. Any info-
Electronics Forum | Fri Mar 27 09:37:15 EDT 2009 | cyber_wolf
There are pem nuts on the back side of the teddy bear face. One of them probably fell off and either shorted your main board or it is lodged in the belt and pulley that drives the advancing wheels. Take the front part of the feeder off that has the t
Electronics Forum | Thu Jan 12 11:41:02 EST 2012 | babe7362000
We are recieving many QFN's in Tubes instead of trays and tape. Does anyone have luck with these in a tube feeder, or vib plate? We cant justify to order a full reel because the cost of the part.
Electronics Forum | Wed Oct 26 10:21:28 EDT 2005 | russ
We are also experiencing problems with this thick stiff paper tape. Our problem is the strength of the spring that supports the tape at its pick position. After a while it just pushes it down because the tape exit wants to bend the tape too sharply
Electronics Forum | Thu Oct 27 08:46:58 EDT 2005 | james
Yes I would have to agree Kemet is the worse. I believe our feeders are just not strong enough to handle the thickness of the tape. It seems to need alot of force to move and to roll the tape through.
Electronics Forum | Thu Oct 27 09:07:50 EDT 2005 | russ
Is anyone aware of the spec for tape if any?
Electronics Forum | Thu Oct 27 12:58:33 EDT 2005 | gregp
EIA-481-B Max tape thickness 1.1mm (not including bottom and top cover tapes which can be .1mm max each) Of course a 1.1mm thick piece of steel will be stiffer than a 1.1mm thick lasagna noodle (already cooked). Is the thickness the issue or is it t
Electronics Forum | Tue Oct 25 14:20:52 EDT 2005 | james
Does anyone else encounter problems using feeders to handle caps that are reeled up with paper tape. We are having alot of problems with vendors that are now using the thicker type (like cardboard) to use to reel up caps. Our feeders either run too
Electronics Forum | Thu Oct 27 09:50:10 EDT 2005 | russ
Thanks Rob, Our tape does meet the Kemet spec but I am actually wondering if there is an EIA spec or something to compare to.
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
