Electronics Forum | Thu Jun 21 01:02:21 EDT 2018 | sophyluo1985
Hi Sir, I think pneumatic is cost effective. but you will find there are so many problem with it in the problem if the condition of the feeder is not very good. So, once you decide to buy the pneumatic feeder, you'd better buy them from you local mar
Electronics Forum | Wed Mar 13 17:13:36 EDT 2013 | isd_jwendell
On an Essemtec machine I solved my sticky tape problem by routing the cover tape different than normal so that it pulls back more instead of up. I'm not familiar with your feeders and don't know if that is even a possibility.
Electronics Forum | Wed Aug 23 13:37:11 EDT 2000 | Sarry
Does anybody have problem with 8 mm paper component reels?. when feeder indexs component, the tape is not separated form the components completely. soemtimes it takes up the paper from the tape.( I believe it is because of tape has sticky material ).
Electronics Forum | Thu Aug 24 09:32:40 EDT 2000 | Stefan Witte
If this is a problem you see with all your paper tape, you may want to talk with your machine vendor. Sometimes a sharper blade in the feeder,which peels off the cover tape, helps to keep the carrier tape together.
Electronics Forum | Fri Mar 25 15:13:30 EST 2005 | pdeuel
Also search "Tape and Reel" useing your favorite search engine. We sometimes have an outside vendor tape this stuff for us. They use generic mod tape that dose not fit properly the parts supplied to them that also causes pick problems.
Electronics Forum | Sun Jun 25 08:51:02 EDT 2006 | cloggy
Problems like these are not caused by bad feeder quality. As described in the solution finding, the pull off forces of the cover tape are just too high. Cause is the blistertape and not the a feeder. Have you ever tested if the pull of force of the
Electronics Forum | Mon May 02 10:18:30 EDT 2005 | Frank
Juki KE-2050R (or any of their R-series machines). They have the ability to automatically learn pick positions on paper tape feeders and they can zoom in on pick locations (x2 or x4), so this will help when they release their nozzle for 01005 compon
Electronics Forum | Mon Nov 24 19:21:04 EST 2003 | alwil
Hi, I have seen this problem. Make sure that the peeler tape goes round all three pulleys as in the diagram on the feeder. Make sure the feeder clutch is oil free and not slipping. If everything is set correctly then it may be a component vendor i
Electronics Forum | Mon Aug 04 21:50:24 EDT 2008 | jti
We're running only our second job on our newly aquired Juki 740 The problem I'm having is as follows, I program the locations, component info, pick info, all fine. When I have the machine measure the component, everything comes up fine, it returns t
Electronics Forum | Wed Feb 08 15:01:30 EST 2023 | rgduval
You'll get as many opinions as you get people who respond to this, and none of them will be wrong :D My career has been on Mycronic machines, so, I know them best. I think Mycronic are hands down the best machines for high-mix, low-volume productio
.gif)
winsouce.jpg)
