Electronics Forum | Thu Dec 15 19:45:15 EST 2005 | Liza
Hi Rob, I would be asking the customers about that. I've read somewhere that teflon is used on feeders, is this a standard and does the absence or presence of this contribute to tape tearing? Thanks, LIza
Electronics Forum | Thu Dec 15 04:55:54 EST 2005 | 00629
Hi Rob, We encountered it on a 6x6mm device, hence, we could consider it as fine pitch. I suppose that it may also have something to do with improvements in the speed of the feeders. Honestly, we don't have that visibility bec our customers do not
Electronics Forum | Thu Dec 15 08:09:06 EST 2005 | GS
Hi Liza, several years ago we had problem like that only with Carrier Tape made by Ploycarbonate material and by using High Speed pick & place. Very few pbms met by using low speed P&P machine. Problems have been solved by using Polystirene Carri
Electronics Forum | Thu Dec 15 06:20:11 EST 2005 | rlackey
Hi Liza, We've seen it occaisionally in house on Universal GSM 8,12,16mm but not on Fuji (except when a feeder's not used for a while). Also on 44, 56 & 72mm (the smaller vol parts I mentioned earlier. It tends not to affect the Hoover Davis Feeder
Electronics Forum | Thu Dec 15 04:26:20 EST 2005 | Rob
Hi Liza, We tend to see it on the larger plastic tape sizes & lower volume parts - such as smd connectors, fine pitch reeled IC's, BGA's etc. We don't tend to get it on high vol parts such as logic, 8 & 16bit micros, v-regs etc. Could this be du
Electronics Forum | Tue Apr 19 11:06:42 EDT 2016 | charliedci
Terra Universal # 1307-95. They are proud of it, but the wire shelving works well with Juki feeders and reeled components.
Electronics Forum | Wed Aug 31 11:23:39 EDT 2022 | stephendo
I don't know Juki but I know stick feeding SO8 ICs. If you have a lot of them regularly then consider getting a tape and reel machine.
Electronics Forum | Fri Apr 01 10:12:41 EDT 2011 | babe7362000
Does anyone else use splice tape on Juki feeders? If so what kind of splice and what kind of tape is being used to connect them? Thanks for any input.
Electronics Forum | Thu Jan 12 11:41:02 EST 2012 | babe7362000
We are recieving many QFN's in Tubes instead of trays and tape. Does anyone have luck with these in a tube feeder, or vib plate? We cant justify to order a full reel because the cost of the part.
Electronics Forum | Fri Nov 04 21:57:37 EDT 2011 | machinehead
When I'm Tearing down a Job, And removing the tape and reel from Agilis Feeder. Their is a gap of at least 10-12 Parts. Unpicked parts, When the knife on the feeder spreads the tape aside. and leaves this gap of feel falling parts.
