Electronics Forum | Wed Feb 05 20:13:13 EST 2020 | sarason
precut wirewrap wires. sarason
Electronics Forum | Thu Nov 14 10:18:31 EST 2019 | slthomas
It doesn't look to me like the jumper wire is wetting at all. I would immediately question the solderability - do you know how that jumper wire is finished (plating type)? Also, how experienced are the solderers? It could be that the wire never get
Electronics Forum | Wed Feb 05 19:14:24 EST 2020 | victorzubashev
Hi all, what you can suggest using as an instant and reliable adhesion for jumper/hook up wires with PTFE insulation during SMT rework on FR4 PCBs? Cheers, Victor
Electronics Forum | Thu Feb 06 07:31:30 EST 2020 | stephendo
Loctite Tak Pak. You can also get an accelerator to go with it.
Electronics Forum | Thu Nov 21 19:55:38 EST 2019 | myke03o
Would like to know what type of soldering iron you are using. On this type of big jumpers, a continuous heating soldering Iron will do the job nicely in order to heat the jumper wire properly.
Electronics Forum | Thu Nov 14 03:12:42 EST 2019 | jefri_simorangkir
hi Team, observed excess solder after assembly jumper with manual solder method. I already try to duplicate the phenomenon with adding more solder tin/wire,adding more time for solder but not found same condition I have attached the image for the
Electronics Forum | Fri Nov 15 11:03:48 EST 2019 | rgduval
I think Steve is on to it. The wire is not getting hot enough to wet. Either the solderer is attempting to solder too quickly, or the PTH is connected to a ground plane. The solder sticking up through the hole leads me to think it's connected to a
Electronics Forum | Wed Dec 10 11:54:15 EST 1997 | Kyle Dopp
I can remember seeing jumper wire that had special insulation that you melt to the board to hold it down instead of gluing. Does anyone use this product and can tell me where to get it.
Electronics Forum | Mon Jul 08 17:07:15 EDT 2013 | wsdauchy
We have 2 CS9100 Schleuniger wire cut/strip machines. They do not have the DISPLAY/PC switch on the back of the CPU card. THe two machines come up PC mode. Any one know of a jumper setting on the CPU board that will allow the machnies to run in DI
Electronics Forum | Wed Sep 23 11:50:34 EDT 1998 | Jeff Ferry
| Can anybody point me to a Standard that provides details on the use of Wire Links for the repair of SMT PCBs, e.g. the maximum number of permissible links, the material to be used, the method of joint etc.? At the next meeting of the IPC Repair com
winsouce.jpg)