Electronics Forum | Wed Jan 22 14:25:17 EST 2014 | rgduval
In the purest sense of ESD control, we would have to say yes, use ESD tape to cover the gold fingers. The gold fingers are connected directly to input/output controls for the card, and, as we all know, when handling boards, we're supposed to avoid c
Electronics Forum | Wed Jan 22 11:07:42 EST 2014 | leardkattiya
Understand that one..but the main issues is..do i really need to use ESD tape or non-ESD tape..since as we all know kapton tape is already expensive..if ESD kapton tape required in SMT line..the cost will be more higher.
Electronics Forum | Tue Jan 21 00:44:30 EST 2014 | leardkattiya
Hi All, I have a question to ask. Do we really need ESD kapton tape to be use inside SMT line/ production? Anyway the purpose of the kapton tape is to protect gold finger/ wirebond area from solder splatter. Please advise.
Electronics Forum | Tue Jul 10 03:51:49 EDT 2007 | vangogh
Hi All, We are producing PCBA with COB process. We are using kapton tape to protect the COB pads from solder splashes/stains. Questions: 1) Is kapton tape an industry accepted way of protecting gold pads from solder splashes? 2) What are the chance
Electronics Forum | Tue Jul 10 07:22:48 EDT 2007 | davef
Q1. Is kapton tape an industry accepted way of protecting gold pads from solder splashes? A1. No. It is more accepted to resolve the reason behind the solder splats, so that the added labor and cost of taping is eliminated. Search the fine SMTnet Arc
Electronics Forum | Wed Jan 22 10:24:23 EST 2014 | cyber_wolf
No matter how good your process is, you will get solder on the gold fingers/lands unless they are protected. We have proven that solder will get on the gold fingers in the reflow oven. How that happens....we arent't 100% sure...there are a lot of the
Electronics Forum | Tue Jan 21 13:40:00 EST 2014 | rgduval
If you're using the Kapton tape to protect the gold fingers from solder splatter, my first instinct is to say,yes, you do need it. I've had the pleasure of paying to have gold fingers reworked in the past. It is not in-expensive; certainly not equa
Electronics Forum | Tue Aug 09 11:56:01 EDT 2005 | Rob
We sometimes use a peelable mask the the PCB manufacturer (board house) adds as part of their process. It may seem an expensive option but avoids: Raising P/o's for tape/peelable mask as consumables booking & inspection Booking out to the shop floo
Electronics Forum | Tue Aug 09 13:25:24 EDT 2005 | pr
From what I can gather, the annular rings are used for grounding when these boards are put in housings. A screw goes through the hole and is torqued down. If there is excess solder on the annular ring, the screw doesn't seat properly. The pallets cov
Electronics Forum | Fri Mar 22 17:14:15 EST 2002 | jseagle
What is the height, width, and length of the connector, packaging? We currently place a 2x20 2mm gull wing SMT connector measuring 8mm H x 38mm L x 6.1mm W, packaged on tape and reel with a plastic pickup in the center. We do this on an Assembleon
