Electronics Forum | Mon Feb 18 09:49:04 EST 2002 | Ashok Dhawan
Anyone using Kester 959 flux on Spray fluxer ? I noticed a black coating on filter element which is installed in supply line ( inside flux tank). The filter element is immersed into flux tank. It is turning blackish due to deposit of flux rosin ?? T
Electronics Forum | Tue Feb 19 15:36:37 EST 2002 | gtemple
We used no clean flux and experience the little filter in the flux tank going black. How long until it goes black? Could the pump be damaged, or you may have to start changing the filter regularily
Electronics Forum | Mon Feb 18 11:08:59 EST 2002 | Claudine Y. Corda
Ashok, a few suggestions.......steel/brass fittings anywhere in the flux line can cause that problem; also, check the transfer tank (if used) for cleanliness . There may be a problem with the pump, if you are using Sono-Tek's SonoFlux system then p
Electronics Forum | Tue Sep 07 12:57:00 EDT 2010 | jrr3434
Thanks for the info mike. How well do these batch cleaners work with densely populated through hole boards that were solder with no clean flux? Is there a problem with water getting trapped under large capacitors? I'm using kester 959t for flux on b
Electronics Forum | Wed Feb 25 01:58:48 EST 2015 | bugarin
Sorry , I`ve got the wrong flux code ,we use NC Kester 959T and we intend to use NC277 VOC-free from AIM, Cheers
Electronics Forum | Tue Dec 11 10:12:36 EST 2007 | George
Hi everybody, Is there any criteria as far as No-clean flux residues surrounding solder joints when using selective solder machines? I have a Novastar SPA 400 and use flux NC kester 959. If I decrease the amount of flux, then I experience problems w
Electronics Forum | Wed Oct 19 08:37:36 EDT 2011 | tombstonesmt
We also have a pillarhouse jade but opted for Kester 959T. The low solids content allows us to use a very small shot of flux thus resulting in low residue on the boards with great solder joints. Solderability is still good but had better results with
Electronics Forum | Tue Feb 24 06:44:50 EST 2015 | bugarin
Hello , We are using Kester 959T flux and we wish to purchase Aim Ws 716 flux, due to higher activity. We also use humiseal 1a33 for conformal coating. Is anyone using Aim flux and humiseal 1A33, are they compatible ? Thank you for info
Electronics Forum | Wed Aug 30 23:45:28 EDT 2000 | Ramon I Garcia C
Hi friends; Steve I'm using flux Kester 959, my top temperature is 187 celcius degrees, my e-mail is ramigary@smtnet.com, Travis I'll check the pcb for contamination, but how may I clean the pcb? may I use alcohol? Nance I cleaned the pipes of the
Electronics Forum | Wed Apr 04 08:55:45 EDT 2012 | tombstonesmt
Dave, *The machine looks to keep a steady 290c (I can confirm) *This problem is machine/product specific. We have three other Pillarhouses that run the same alloy/flux but only run this one product at this station. *The solder does have a "tail" whil