Electronics Forum | Sun Sep 02 13:45:06 EDT 2007 | mun4o
Hi, we use om338 from alpha metals in our smt production lines.I wont change this solder paste with kester em 918.Is anybody use this solder paste?what yo think abaout this paste.Is it good?
Electronics Forum | Mon Feb 04 05:07:33 EST 2008 | mun4o
Hi, we have about 100L kester 108 - soldering flux thinner.That is thiner for Kester 2235 and some other fluxes.But we have not use this flux already, and I don't know what I can make with the tinner.Could you help me - what is chemical composition
Electronics Forum | Wed Aug 25 14:40:24 EDT 1999 | hammer
Has anyone used bar solder from a company called "Electrum Inc." What kind of results did you have?
Electronics Forum | Wed Aug 25 19:46:25 EDT 1999 | Dave F
| Has anyone used bar solder from a company called "Electrum Inc." | What kind of results did you have? | | Hammer: Try: Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-396-9390 John S
Electronics Forum | Thu Aug 26 08:17:07 EDT 1999 | Brian
| | Has anyone used bar solder from a company called "Electrum Inc." | | What kind of results did you have? | | | | | Hammer: Try: | | Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-3
Electronics Forum | Thu Aug 26 08:15:13 EDT 1999 | Brian
| | Has anyone used bar solder from a company called "Electrum Inc." | | What kind of results did you have? | | | | | Hammer: Try: | | Electrum Recovery Works 827 Martin St Rahway, NJ 07065 908-396-1616 800-622-1192 Canada 800-535-1192 Fax: 908-3
Electronics Forum | Wed Aug 23 14:59:32 EDT 2006 | bill
I�ve been lurking on the forum for a while so I will take a stab at this, mainly because there is no answer I take it that you have a variety of boards being produced at the same time and are in fixtures so the conveyors don�t need to be adjusted, a
Electronics Forum | Mon May 15 11:16:10 EDT 2006 | timnop
In an attempt to re-establish this thread as a serious request for professional experience and opinions on the Kester K100LD product, let me ask again!..... Have any of you professionals out there tried this product and if so, what was your experienc
Electronics Forum | Mon May 15 11:26:41 EDT 2006 | russ
Tim, call kester and ask for references who better than them to tell you who is using. Russ
Electronics Forum | Fri May 12 12:07:10 EDT 2006 | solderiron
The kester better known as KY'd Sn/Cu has more copper intermetallic growth over time, dissolves copper from the board faster so repairing and touchup can damage board. Bridges more than SN100c. Does not thermal cycle well. Has shrink cracks that can
