Electronics Forum | Mon Dec 17 13:58:54 EST 2007 | ck_the_flip
I made my own wave measuring device using KIC2000 system. KIC2000 has automatic wave detection, so now I have a profiler for both reflow ovens and wave solder. The delmat carrier only cost $500. A guy, Samir, from this forum gave me the idea, actu
Electronics Forum | Mon Mar 02 23:08:50 EST 1998 | Scott McKee
| | Can anyone advise a good starting point for a temp profile for | | on 0.05" and 1206 component boards? These boards are simple | | by todays standards and do not contain any fine pitch or | | other special components. | | Thanks in advance... |
Electronics Forum | Mon Mar 02 09:45:08 EST 1998 | Justin Medernach
| Can anyone advise a good starting point for a temp profile for | on 0.05" and 1206 component boards? These boards are simple | by todays standards and do not contain any fine pitch or | other special components. | Thanks in advance... | MM Mike,
Electronics Forum | Wed Sep 13 13:35:06 EDT 2006 | Mitch Crumbstein
It took me awhile to "warm up" to KIC 2000 as well, as I, too, am an old lead-head from way back who used to profile with an old MOLE that used DOS-based software. I've also used the old SlimKIC II and Datapaq as well. I guess what he meant by "old
Electronics Forum | Mon Aug 14 10:35:00 EDT 2000 | C.K.
We've got this power brick device with a Copper casing that gets so hot in the oven, that the solder on the circuit board inside the power brick reflows. Of course, the heat is abosorbed by the case. Profile adjustments have been tried, but we don'
Electronics Forum | Tue Jul 11 15:59:52 EDT 2000 | JohnW
George, I looked at the winkic & profit software and tool's a while ago along with some of the alternatives. No matter what anyone tell's you in the 1st instance you do still need a profile card as what you are doing is comparing the known good prof
Electronics Forum | Thu May 26 15:59:40 EDT 2005 | davef
Let�s not get drawn into making more of the amount of training required in order to be able to develop an effective reflow recipe than is necessary. A low-skilled operator with about one hour's training can setup the solder reflow oven. Consider co
Electronics Forum | Wed Sep 13 10:31:14 EDT 2006 | CL
Hello Brad, We are running the Slim Kic 2000. We have found the predictions to be fairly accurate as long as the suggested change is within 20 degrees of the original recipie. As a test I ran a board with the wrong profile. The predictions got me wi
| 1 |
