Electronics Forum | Wed Feb 21 17:27:02 EST 2001 | jollyrodger
HELP...... I have recently taken on the post of line technician at my place of work. I require as much information as you can give me on all SMT processes. We work with Fuji CP643E, Philips FCM, Dek 265, Universal GSM, BTU Paragon ovens. All infor
Electronics Forum | Thu Oct 20 11:52:07 EDT 2005 | Amol
there are various SMT machines 1. Stencil Printer 2. Pick and Place machine 3. Reflow ovens 4. Automatic optical Inspection machines start with visitng Stencil printer websites like MPM, DEK etc. Pick and Place -- Univesal instruments, Mydata, Fuji
Electronics Forum | Thu Dec 28 22:00:45 EST 2006 | Sue Kim
Hi all, I am doing some research on SMT machines. I would like as many people as possible to rate the following machines 1-6. The number 1 would be the best, number 6, the least desirable of the 6. I realize that there are dozens of factors to con
Electronics Forum | Fri Nov 18 14:08:44 EST 2011 | babe7362000
Is there anyone close to Ohio or in Ohio that is very familiar with the TRITON SMT IV Washer? Our tank is not staying hot to run boards thru. The temperature drops to 116. We checked all the heaters and they seem to be running fine. Any info is ap
Electronics Forum | Mon Nov 21 06:36:56 EST 2011 | babe7362000
We checked all of what you mentioned and not sure what is going on. Everything seems to test out fine.
Electronics Forum | Mon Dec 05 11:24:29 EST 2011 | andersenequipment
I am not in ohio but I can service it. My rates beat anyone else, hands down. I will be on the road next week and may be available to stop by and diagnose.
Electronics Forum | Thu Dec 01 13:24:45 EST 2011 | kmakiya
Sounds like you have a bad heater. Check current on each leg of the heater circuit, CON6 for the wash and CON7 for the rinse. The current should be the same on each leg. Trek is now part of Stoelting, tech support is 920-894-2293. Hope this helps if
Electronics Forum | Fri Nov 18 15:06:44 EST 2011 | jeffharley
Have you checked each heater rod with a fluke temp. meter or similar to make sure that the elements are in fact heating up? Make sure you have voltage to all heater rods. Check to see what the plc controller is set at. Hope this helps.
Electronics Forum | Wed Aug 10 01:28:40 EDT 2022 | davef
Below are several suppliers. KingFei and FKN Systek sponsor SMTnet. KingFei SMT Tech [ https://smtnet.com/company/index.cfm?fuseaction=view_company&company_id=53598 ] FKN Systek Products [ https://smtnet.com/company/index.cfm?fuseaction=product_cat
Electronics Forum | Mon Jan 31 21:11:09 EST 2000 | Dave F
Dave: Find: "Comprehensive Surface Mount Reliability Model Covering Several Generations of Packaging and Assembly Technology", by J. Clech et.al. IEEE Trans on Comp. Hyb. and Manuf. Tech. Vol. 16, No. 8 Dec. 1993, p.949. It listed cycle to failure
A US manufacturer of quality hand tools for those engaged in the repair, rework, R & D, testing, and assembly of electronic components and printed circuit boards from Through Hole to 2Mil Pitch Surface Mount.
98 Elm St.
Portland, ME USA
Phone: 1-207-775-6139