Electronics Forum | Tue Dec 07 22:05:19 EST 1999 | sin
Added to MARK suggestion, you should verify you xy table height also by using the meter listed in the maintenace manual. If everything is fine, then i suggest you should check the placement air kisses( can suck your component back up or release to q
Electronics Forum | Wed Oct 19 13:07:04 EDT 2016 | cyber_wolf
Are there indentations in the paste ? If there is, you have a couple things to look at off the top of my head:1) make sure your spool valves are shutting completely off. 2) make sure there is nothing sticky on your nozzles.3) Adjust the blow off/ "ki
Electronics Forum | Fri Jul 22 14:52:47 EDT 2022 | tpratt
Not a problem, it forced me to put on my big boy pants and figure it out for myself. I felt pretty dumb when I realized what I had missed. If you have any custom procedures made up for maintaining the solder pumps and pot that would be great. I'm n
Electronics Forum | Tue Feb 22 12:02:11 EST 2005 | siverts
The first thing to do, as always with any trouble shooting, is to try to isolate your problem area, then it is much easier to pinpoint and find a solution for the problem. Some simple checks you can do, besides the good suggestions you got from some
Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick
You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i
| 1 |
.gif)
