Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Fri Mar 22 14:07:00 EDT 2019 | proceng1
I believe that NORDSON now recommends AIM NC277. Nordson bought out ACE-protech.
Electronics Forum | Wed Feb 13 13:30:03 EST 2019 | emeto
I personally prefer a NC process if I have to chose. AIM flux was good NC377 I think(they keep changing names), NF 372 from and many more. You can make them all work...the KISS 104 ...
Electronics Forum | Fri Feb 08 10:52:24 EST 2019 | roblackey
BLT 31-41 "No Clean Selective Flux For Aerospace" On a Versaflow 3/45 Atomises well, good hole penetration, good wetting, cleans off well in the solvent cleaner. Use for SN100C, SA0307, and 60/40.
Electronics Forum | Fri Mar 22 14:19:38 EDT 2019 | gregcr
Thank you ProcEng1 Nordson sent me a flux suggestion list: No Clean: 1. Kester Select 10 2. ALPHA EF-2210 3. AIM FX-16 Water Sol: KESTER 2331-ZX Nozzle Tinning: SUPERIOR #75
Electronics Forum | Thu Feb 07 12:50:21 EST 2019 | gregcr
Hi All, What are you running for selective solder flux? I'd like any opinion on water soluble and/or no-clean fluxes you are using. In our Kiss 104 machine we use HYDRO-X20 water soluble flux, per the original install suggestion, but I'd like to k
Electronics Forum | Fri Jun 23 15:11:11 EDT 2017 | emeto
Try add a pre-heater. If not change the process or the machine. With KISS you will hardly get any PCB to work properly.
Electronics Forum | Wed Jul 07 12:57:24 EDT 2021 | emeto
One of these ACE KISS machines. Very basic and simple to program. It is a great entry level machine. However, accuracy and repeatability not the same compared to the big expensive machines.
Electronics Forum | Fri Jun 23 12:54:53 EDT 2017 | guts1872
We are having issues with top fill and dropping pins on Molex connectors with our KISS 101. Unfortunately we do not have a pre heater and bottom side pre heat with our nozzles is not satisfactory. Most of the issues occur when using a no clean proces