Electronics Forum | Tue Oct 22 14:43:20 EDT 2019 | kathylci
Looking for someone to speak with regarding a Koh Young 3030VAL. Want to find out some information on the ease of programming for this unit. Any help is greatly appreciated! Thanks- Kathy
Electronics Forum | Sat Nov 09 14:15:18 EST 2019 | linux
Perhaps I can help you out, have experience with kohyoung Spi and AOI
Electronics Forum | Thu Mar 24 23:41:40 EDT 2022 | glasscake
Another oddity, when I unplug the PCI1/2 cables and cycle power I still get the same error.
Electronics Forum | Fri Mar 26 08:55:45 EDT 2021 | manaik
Hello, We have purchased used Koh Young AOI, the setup does not let us through when you start MCS on start, it says RJ45 connector is out, which is not. delta tau clipper conntroller. The swithc on INIT must be ON or OFF? Do the lights work even wi
Electronics Forum | Sat Mar 30 14:02:48 EDT 2024 | poly
I've bought a used ky 8030 spi that has a software fault. I've got the software restore from Koh Young but i can get any debugging info to see if the hardware works. I assume win mcs is the interface to the hardware but all the debugging options are
Electronics Forum | Tue Apr 16 14:14:34 EDT 2024 | poly
Does anyone have a maintenance or other manual for a ky 8030? I'd love a wiring diagram and any debugging / maintenance info.
Electronics Forum | Mon Apr 22 00:02:39 EDT 2024 | poly
That was handy! I'd love to get a wiring diagram though, mostly because I'm worried that the reason that the machine is not working is because a bit is missing... I've taken a photo of the inside and there's a markings where it looks like a board use
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Mon Mar 28 23:52:08 EDT 2022 | glasscake
Seemed to have fixed it. When reassembling the gray PC I noticed the motion controller card can be pushed into the PCI connector rather deep. once i raised it up and only pushed it as far as the washer would have it go in it started to work again. I
